Panasonic NC-EH30PC NCEH22P User Guide - Page 21

Clean with Citric Acid, Maintenance

Page 21 highlights

Maintenance When scale has adhered Clean with Citric Acid  Make sure that the mesh filter is attached to the container.  Put citric acid in the inner container. ● Amount of citric acid to be used at one time: 80 g (two packages) or seven level tablespoons. once every two or three months Citric acid The citric acid is available from an authorized dealer. (Model No: SAN-80N) * Follow the directions for cleaning printed on the citric acid package. * Since the citric acid used for cleaning is a food additive, it is harmless to humans.  Add water to the maximum water level mark, and mix the citric acid and water well. Close the lid.  Connect the plug immediately after stirring and press the key more than 3 seconds. Cleaning start End of cleaning Lit Flashing Cleaning time (approx.) NC-EH40P: 50 Min. NC-EH30P: 42 Min. NC-EH22P: 35 Min. Indications will note when cleaning ends.  Dispense some water, then unplug, remove the lid and throw away the hot water via the "DRAIN" mark.  Refill with water and boil it to remove the smell of the citric acid or lemons.  Then throw the hot water away in the same way as in step . ● To remove any discoloration from the area above the maximum water level, rub the inside lightly with a wet sponge. ● If the discoloration cannot be removed by rubbing, clean the inner container several times using citric acid or lemons. Cautions ● Use only our citric acid to clean this thermo pot. ● Do not fill with water above maximum water level. ● Fill the container only with tap water (do not fill with hot water). Hot water may spout out causing burns. 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52

21
Cleaning start
Maintenance
When scale has adhered
Clean with Citric Acid
once every two or
three months
Make sure that the mesh filter is attached to the container.
Put citric acid in the inner container.
Amount of citric acid to be used at one time:
80
g
(two packages) or seven level tablespoons.
The citric acid is available from an authorized dealer.
(Model No: SAN-80N)
* Follow the directions for cleaning printed on the citric acid package.
* Since the citric acid used for cleaning is a food additive, it is harmless to humans.
Add water to the maximum water level mark, and
mix the citric acid and water well. Close the lid.
Citric acid
Connect the plug immediately after stirring and press the
key
more than 3 seconds.
Indications will note
when cleaning ends.
Cleaning time
(approx.)
NC-EH40P: 50 Min.
NC-EH30P: 42 Min.
NC-EH22P: 35 Min.
Dispense some water, then unplug, remove the lid and throw away the hot water via
the “DRAIN” mark.
Refill with water and boil it to remove the smell of the citric acid or lemons.
Then throw the hot water away in the same way as in step
.
To remove any discoloration from the area above the maximum water level, rub the inside lightly
with a wet sponge.
If the discoloration cannot be removed by rubbing, clean the inner container several times using
citric acid or lemons.
Cautions
Use only our citric acid to clean this thermo pot.
Do not fill with water above maximum water level.
Fill the container only with tap water (do not fill with hot water). Hot water may spout out causing burns.
End
of cleaning
Lit
Flashing