Panasonic PT-LB10U Portable Projector -multi-lang - Page 17
AUTO SETUP button, RGB INPUT indicator - lamp replacement
UPC - 791871111086
View all Panasonic PT-LB10U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Preparation # RGB INPUT indicator This indicator illuminates when a signal is being input to the RGB IN connector. $ LAMP indicator (page 51) This indicator illuminates when it is time to replace the lamp unit. It flashes if a circuit abnormality is detected. % TEMP indicator (page 50) This indicator illuminates if an abnormally high temperature is detected inside the projector or around it. If the temperature rises above a certain level, the power supply will be turned off automatically and the indicator will flash. & Power indicator (pages 24, 26 and 27) This indicator illuminates red when the projector is in standby mode, and it illuminates green when a picture starts to be projected. ' POWER button (pages 24 and 26) ( INPUT buttons (page 25) These buttons are used to switch the input signals from the connected equipment. ) AUTO SETUP button (pages 25 and 28) If this button is pressed while a picture is being projected, the projection settings will be adjusted automatically in accordance with the signal being input. In addition, the angle of tilt of the projector will be automatically detected and adjusted in order to correct any keystone distortion. * MENU button (pages 32 and 34) This button is used to display the "MAIN MENU". When a menu screen is being displayed, this button can be used to return to a previous screen or to clear the screen. + Arrow (FGI and H) buttons (page 34) These buttons are used to select and adjust items in the on-screen menus. , ENTER button (page 34) This button is used to accept and to activate items selected in the on-screen menus. - FREEZE button (page 29) This button is used to momentarily freeze projection so that a still picture is displayed. . SHUTTER button (page 29) This button is used to momentarily turn off the picture and sound. / VOLUME +/- buttons (page 30) These buttons are used to adjust the volume of the sound output from the projector's built-in speaker. Refer to page 33 for details on how to adjust the volume using the buttons on the projector control panel. 0 STD (standard) button (page 35) This button is used to reset the projector adjustment values to the factory default settings. 1 INDEX WINDOW button (page 31) This button can be used to split the image projection area into a still picture and a moving picture. When "NETWORK" is selected, screen display will be switched. 2 D.ZOOM +/- buttons (page 30) These buttons are used to enlarge the projected image. ENGLISH-17