Panasonic PT-LB10U Portable Projector -multi-lang - Page 63
Others, Control commands, Cable specifications, Command, Control, Contents, Remarks
![]() |
UPC - 791871111086
View all Panasonic PT-LB10U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Control commands The commands which the personal computer can use to control the projector are shown in the following table. Command Control Contents PON Power ON POF Power OFF Remarks In standby mode, all commands other than the PON command are ignored. B The PON command is ignored during lamp ON control. B If a PON command is received while the cooling fan is operating after the lamp has switched off, the lamp is not turned back on again straight away, in order to protect the lamp. AVL IIS Q$S Volume Input signal selection Lamp ON condition query Parameter 000-063 (Adjustment value 0-63) Parameter VID=VIDEO SVD=S-VIDEO RG1=RGB (YPBPR) NWP=NETWORK (PT-LB10NTU only) Callback 0 = Standby 1 = Lamp ON control active 2 = Lamp ON 3 = Lamp OFF control active Cable specifications (When connected to a personal computer) At the projector 1 2 3 4 5 6 7 8 At the computer (DTE specifications) 7 8 3 5 2 6 1 4 9 Others ENGLISH-63
![](/manual_guide/products/panasonic-ptlb10u-portable-projector-multilang-777d327/63.png)