Panasonic PT-LB10U Portable Projector - Page 23
Adjustments and settings, FRONT, CEILING - pt lb10svu
UPC - 791871111086
View all Panasonic PT-LB10U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
AUTO SEARCH This should normally be set to "ON" ON When the power is turned on and "AUTO SETUP" is running, the projector detects which signals are being input and uses these signals for projection. (If a picture is being projected, the signal source is not automatically changed.) OFF Use this setting when you do not want the signal source to be changed automatically when the power is turned on and "AUTO SETUP" is running. AUTO SIGNAL This should normally be set to "ON". ON "AUTO SETUP" will be carried out automatically when the input signal is changed. OFF "AUTO SETUP" will not function when the input signal is changed. AUTO KEYSTN This should normally be set to "ON". ON During "AUTO SETUP", the angle of tilt of the projector is detected and keystone distortion is corrected automatically. OFF Use this setting when you do not want automatic keystone correction to be carried out during "AUTO SETUP", such as when the screen itself is at an angle. RGB/YPBPR RGB/YPB PR AUTO [ RGB [ YPB PR This should normally be set to "AUTO". RGB or YPBPR is selected automatically depending on the synchronising signal status. When 480i, 576i, 480p, 576p, 1 080/60i, 1 080/50i, 720/60p and some VGA480 signals are being input, select "RGB" or "YPBPR" in accordance with the input signal. VGA60/480p VGA60/480p 480p [ VGA60 Set to "VGA60" when 59.9Hz VGA480 signals are being input (refer to page 60 for details). Set to "480p" when 480p RGB signals are being input. SXGA MODE SXGA MODE SXGA [ SXGA+ This setting is only for an SXGA signal. SXGA Select this item normally. SXGA+ When the edges of the projected image are not visible, select this item. 44-ENGLISH Noise Reduction (NR) (S-VIDEO/VIDEO only) If noise occurs from the projector because of a poor input signal, set "NR" to "ON". To turn off the "NR" feature, set it to "OFF". BLACKBOARD (PT-LB10NTU/PT-LB10U/PTLB10SU/PT-LB10SVU only) Set to "ON" when "PICTURE MODE" is set to "BLACK-BD". (Refer to page 37.) BACK COLOR BACK COLOR BLUE [ BLACK This sets the color which is projected onto the screen when no signal is being input to the projector. FRONT/REAR FRONT/REAR FRONT [ REAR This setting should be changed in accordance with the projector setting-up method. (Refer to page 19.) FRONT When the projector is placed in front of a screen. REAR When using a translucent screen. DESK/CEILING DESK/CEILING DESK [ CEILING This setting should be changed in accordance with the projector setting-up method. (Refer to page 19.) DESK When the projector is placed on a desk or similar. CEILING When the projector is suspended from a ceiling using the ceiling bracket (sold separately). FAN CONTROL FAN CONTROL STANDARD [ HIGH Set "FAN CONTROL" to "HIGH", when using this projector at high elevations (above 1 400 m) only. LAMP POWER LAMP POWER HIGH [ LOW This setting changes the lamp brightness. When set to "LOW", the luminance of the lamp is reduced, but the projector uses less power, and the operating noise is also reduced. This can help to extend the lamp's operating life. If using the projector in small rooms where high luminance is not required, it is recommended that you set the "LAMP POWER" to "LOW". NOTE: B "LAMP POWER" cannot be set when no signal is being input. ENGLISH-45 Adjustments and settings