Panasonic PT43LC14 Multi Media Display - Page 7
Accessories, Remote Control Battery Installation - reset
View all Panasonic PT43LC14 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Getting Started Accessories 1. Remote Control (EUR7627Z20) 2. Batteries 2 "AA" 3. RGB Cable (2 m) (LSJA0239-1 or LSJA0443) Before Using Remote Control Battery Installation Requires two AA batteries (supplied). 1. While pressing in on the catch, open cover in direction of arrow. 2. Install the batteries as shown in the battery compartment. (Polarity + or - must match the markings in the compartment). 3. Press cover in direction of arrow until it snaps shut. Two AA size CAUTION Incorrect battery installation can cause the batteries to leak, leading to personal injury and/or damage to the remote control. Observe the following precautions: 1. Batteries should always be replaced as a pair. Always use new batteries when replacing the old set. 2. Do not mix battery types (example: "Zinc Carbon" with "Alkaline"). 3. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries. 4. Battery replacement is necessary when the remote control acts sporadically or stops operating the projection display set. Helpful Hints: (1) For frequent remote control users, replace old batteries with Alkaline batteries for longer battery life. (2) Whenever you remove the batteries, you may need to reset the remote control infrared codes. We recommend that you record the code on page 74, prior to setting up the remote. 7