Panasonic PTAE200U PTAE200U User Guide - Page 20

Adjusting the position When the input signal is from a PC, first select AUTO SETUP and then press the ENTER button to initiate automatic positioning. If the optimum setting is not obtained when AUTO SETUP is carried out, adjust by the following procedure. Use the F and G buttons to select an item, and then use the I and H buttons to change the setting for that item. For items with bar scales, press the ENTER button or the I or H buttons to display the adjustment screen, and then use the I or H buttons to make the adjustment. When an S-VIDEO/VIDEO/ YPBPR /DVI signal is being input or SD CARD is selected. POSITION H-POSITION 0 V-POSITION 0 ASPECT 16:9 SELECT ENTER ESC B "ASPECT" can be adjusted only when a DVI signal is being input or when "SD CARD" is selected. When an PC signal is being input POSITION H-POSITION 0 V-POSITION 0 DOT CLOCK 0 CLOCK PHASE 0 ASPECT 4:3 AUTO SETUP SELECT ENTER ESC VERTICAL POSITION (S-VIDEO/VIDEO/YPBPR/PC only) Press the I button to move the picture down, and press the H button to move the picture up. DOT CLOCK (PC only) Periodic striped pattern interference (noise) may occur when a striped pattern such as the one below is projected. If this happens, use the I and H buttons to adjust so that any such noise is minimised. CLOCK PHASE (PC only) Adjust the DOT CLOCK setting first before carrying out this adjustment. Use the I and H buttons to adjust so that the noise level is least noticeable. NOTE: B If signals with a dot clock frequency of 100 MHz or higher are being input, interference may not be completely eliminated when the DOT CLOCK and CLOCK PHASE adjustments are carried out. HORIZONTAL POSITION (S-VIDEO/VIDEO/YPBPR/PC only) Press the I button to move the picture to the left, and press the H button to move the picture to the right. 38-ENGLISH ASPECT Refer page 30. AUTO SETUP (PC only) HORIZONTAL POSITION, VERTICAL POSITION, DOT CLOCK and CLOCK PHASE are matched to the input signal and are automatically adjusted. NOTE: B When the ASPECT is set to V- SCROLL (page 30), AUTO SETUP cannot be performed. Option settings Use the F and G buttons to select an item, then press the I or H buttons to change the setting. OPTION OSD ON NR ON PC PRIORITY NORMAL BACK COLOR BLACK 4:3 H-POS CENTER FRONT/REAR FRONT D E S K / C E I L I N G DESK FAN CONTROL NORMAL LAMP POWER HIGH LAMP RUNTIME 5H SELECT ADJ ESC OSD OSD ON [ OFF ON OFF The signal name is displayed in the top-right corner of the screen when the input signal is changed. Use this setting when you do not want the signal name to be displayed. NR (Noise Reduction) (S-VIDEO/VIDEO/YPBPR only) NR ON [ OFF If noise occurs from the projector because of a poor input signal, set NR to "ON". To turn off the NR (Noise Reduction) feature, set it to "OFF". PC PRIORITY (PC only) PC PRIORITY NORMAL [ WIDE NORMAL displays the PC screen data in a 4:3 aspect ratio. WIDE displays the PC screen data in a 16:9 aspect ratio. BACK COLOR BACK COLOR BLACK [ BLUE This sets the color which is projected onto the screen when no signal is being input to the projector. This sets the background color for the left/right margins when the 4:3 aspect ratio is selected. (Refer to page 31.) ENGLISH-39 Advanced Operation Basic Operation