Panasonic PTAE200U PTAE200U User Guide - Page 27
CLEANING AND REPLACING THE AIR FILTER, Cleaning procedure
View all Panasonic PTAE200U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
LAMP indicator Indicator display Illuminated (red) It is nearly time to Problem replace the lamp unit. Flashing (red) An abnormality has been detected in the lamp circuit. B Does "REPLACE Possible cause LAMP" appear on the screen after the projector is turned on? B The power may have been turned on straight away after it was turned off. B There may be an abnormality in the lamp circuit. B This occurs when B Wait for a while B Turn off the MAIN the operation time until the lamp unit POWER switch by for the lamp unit is cools down before following the nearing 1800 turning the power procedure given hours. (when back on again. on page 23, and LAMP POWER then contact an Remedy has been set to "HIGH") Ask your Authorised Service Center. dealer or an Authorised Service Center to replace the lamp unit. NOTE: B Be sure to turn off the MAIN POWER switch by following the procedure given in "Turning off the power" on page 23 before carrying out any of the procedures in the "Remedy" column. B If the main power turns off after the TEMP indicator starts flashing, it means that an abnormality has occurred. Please contact an Authorised Service Center so that the necessary repairs can be made. 52-ENGLISH Cleaning and replacing the air filter If the air filter becomes clogged with dust, the internal temperature of the projector will rise, the TEMP indicator will flash and the projector power will turn off. The air filter should be cleaned every 100 hours of use, depending on the location where the projector is being used. Cleaning procedure # Turn off the MAIN POWER switch and disconnect the power cord plug from the wall outlet. Turn off the MAIN POWER switch according to the procedure given in "Turning off the power" on page 23 before disconnecting the plug from the wall outlet. $ Gently turn the projector upside down. & Clean the air filter. Use a vacuum cleaner to clean off any accumulated dust. NOTE: B Place the projector on top of a soft cloth so that it will not become scratched. % Remove the air filter. Put your fingernails under the air filter and pull the air filter out of the projector. NOTE: B Be careful not to let the air filter get sucked into the vacuum cleaner. ' Install the air filter. NOTE: B Be sure to install the air filter cover before using the projector. If the projector is used without the air filter cover installed, dust and other foreign particles will be drawn into the projector, and malfunctions will result. B If the dust cannot be removed by cleaning, it is time to replace the air filter. Please consult your dealer. Furthermore, if the lamp unit is being replaced, replace the air filter at this time also. Air filter ENGLISH-53 Others