Panasonic PTAE3000U PTAE3000U User Guide - Page 11
About Your Projector, Remote control
View all Panasonic PTAE3000U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Preparation About Your Projector Remote control Power button While the MAIN POWER button is on, switch between standby mode and projection mode. (page 21) Remote control signal emitter Emit remote control signal. (page 23) Button backlight When any button is pressed, the button backlight is lit. Without any operation, it gets darker after 5 seconds and goes off after next 5 seconds. Display the PICTURE menu or ADVANCED MENU. (page 23) Switch to cycle through the PICTURE MODE. (page 23) Switch to cycle through the aspect ratio. (page 24) Display the main menu or return to the previous menu. (page 29) Navigate through the menus with FGIH, and activate the menu item with the ENTER button. (page 29) Reset some of the settings to the factory default. (page 28) Switch to cycle through the input method. (page 28) Display the LENS CONTROL menu. (page 23) Display the MEMORY LOAD menu. (page 24) Display the COLOR MANAGEMENT menu. (page 26) Display the input waveform. (page 24) Return to the previous menu. (page 29) Capture the projected image as a still image. (page 28) Activate the assigned function from the menu options for shortcut. (page 42) Battery compartment 1. Press the tab and lift up the cover. 2. Insert the batteries according to the polarity diagram indicated inside. NOTE: • Do not drop the remote control. • Avoid contact with liquids or moisture. • Use manganese batteries or alkaline batteries with the remote control. • Do not attempt to modify or disassemble the remote control. Contact an Authorized Service Center for repairs. • Do not keep pressing the remote control buttons as this may shorten battery life. • See "Remote control operation" on page 23. ENGLISH - 11