Panasonic PTAE3000U PTAE3000U User Guide - Page 44
Installation, Sleep, High Altitude Mode, Lamp Power, Lamp Runtime - lamp life
View all Panasonic PTAE3000U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
OPTION menu INSTALLATION When installing the projector, select the projection method according to the projector position. Press I H to cycle through the options. See "Projection method" on page 15. FRONT/DESK FRONT/CEILING REAR/DESK REAR/CEILING Setting on a desk/floor and projecting from front Mounting on the ceiling and projecting from front Setting on a desk/floor and projecting from rear Mounting on the ceiling and projecting from rear SLEEP You can select the required duration of time and set the off timer to turn off the power of the projector automatically. 3 minutes before turn-off, the countdown of minutes will be displayed in the lower right corner. Press I H to cycle through the options. OFF 240MIN. 60MIN. 210MIN. 90MIN. 180MIN. 120MIN. 150MIN. HIGH ALTITUDE MODE If you use the projector at high elevation, the HIGH ALTITUDE MODE setting need to be ON to set the fan speed high. Press I H to select the required option. OFF The fan speed is low. ON The fan speed is high. NOTE: • At 1 400 - 2 700 m (4 593 - 8 858 ft) above sea level, the setting must be ON. • The loudness of fan noise depends on the HIGH ALTITUDE MODE setting. LAMP POWER You can adjust the power of the lamp to save on electricity, prolong the lamp life and reduce the noise. Options Function NORMAL ECO-MODE When higher luminance is required. When lower luminance is sufficient. NOTE: • When no input signal is detected, the function is disabled. LAMP RUNTIME You can check how long the lamp has been used. NOTE: • LAMP RUNTIME is a relevant matter for lamp replacement timing. See "Replacing the lamp unit" on page 47. Settings 44 - ENGLISH