Panasonic PTFW300NTU Lcd Projector - Page 42

PROJECTOR SETUP menu INSTALLATION FUNCTION BUTTON When installing the projector, select the projection method according to the projector position. Press I H to cycle through the options. See "Projection method" on page 16. FRONT/DESK FRONT/CEILING REAR/DESK REAR/CEILING Setting on a desk/floor and projecting from front Mounting on the ceiling and projecting from front Setting on a desk/floor and projecting from rear Mounting on the ceiling and projecting from rear You can assign a certain menu function to the FUNCTION button as shortcut. Press I H to select the required menu option, and the ENTER button. Options DISABLE ASPECT PICTURE MODE DAYLIGHT VIEW CLOSED CAPTION Functions Deactivate the FUNCTION button. Display the ASPECT menu. Display the PICTURE MODE menu. Display the DAYLIGHT VIEW menu. Press to turn on/off the CLOSED CAPTION. Refer 36 33 34 38 HIGH ALTITUDE MODE If you use the projector at high elevation, the HIGH ALTITUDE MODE setting needs to be ON to set the fan speed high. Press I H to select the required option. OFF The fan speed is low. ON The fan speed is high. NOTE: • At 1 400 m (4 593 ft) above sea level, the setting must be ON. • The loudness of fan noise depends on the HIGH ALTITUDE MODE setting. EMULATE You can switch to the Panasonic past model's control commands for COMPUTER connection. DEFAULT D3500 D4000 D/W5K series L730 L780 L735 L785 LB/W80 F100, FW100, F200, F300, FW300 models D3500 models D4000 models D5500, DW5000, D5600, DW5100, D5700 models L520, L720 models L750, L780 models L735 models L785 models LB75, LB80, LW80 models NOTE: • Without any operation for 5 seconds, the displayed menu will be disappeared. AUDIO SETTING J VOLUME You can adjust the volume of the built-in monaural speaker and VARIABLE AUDIO OUT terminal. I Decrease H Increase J BALANCE You can adjust to hear the sound played equally through both right and left from VARIABLE AUDIO OUT, or shift the balance so more sound plays through the left or right side. I More sound plays through the left side H More sound plays through the right side J IN STANDBY MODE You can switch on/off the sound output in standby mode. OFF No sound in standby mode. ON Output audio in standby mode. J AUDIO IN SELECT You can switch the audio output method for COMPUTER1 IN, COMPUTER2 IN and DVI-D IN terminals. Q DVI COM.AUDIO IN 2 Output audio that is input to the COMPUTER AUDIO 2. AUDIO IN Output audio that is input to the AUDIO IN. Q COMPUTER1 COM.AUDIO IN 1 Output audio that is input to the COMPUTER AUDIO 1. AUDIO IN Output audio that is input to the AUDIO IN. ENGLISH - 42 Settings