Panasonic RX400U CQRX100U User Guide - Page 13
Preparation - cq install
UPC - 037988758357
View all Panasonic RX400U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Preparation 1 Set your car's ignition switch ACC to the ACC or ON position. ON 2 Press [SRC] (PWR: Power). First Time Power On Cancellation of Demonstration Batter y Installation \CQ-RX400U\ \CQ-RX200U\ The demonstration message appears for initial use. 1 Set your car's ignition switch to the ACC or ON position. \CQ-RX400U\ 4 Press [VOL] (PUSH SEL: Select) to select DEMO. 5 Turn [VOL] counterclockwise. For using the remote control, press [0] (). \CQ-RX200U\ 2 Press [SRC] (PWR: Power). 3 Hold down [VOL] (PUSH SEL: Select) for 2 sec. or more to open the function menu. Notes: • To return to the regular mode, press [DISP]. • Refer to the section on "Function Settings". • When "NO USB" (\CQ-RX400U\) or "NO DISC" is displayed, the Demonstration cannot be cancelled. Pull the insulation film out from the backside of the remote control gently. Note: Battery Information: Battery Type: Panasonic lithium battery (CR2025) (Included in the remote control) Battery Life: Approximately 6 months under normal use (at room temperature) The 12-hour system is used for the clock. 1 Press [DISP]. (clock display) 2 Hold down [DISP] for more than 2 seconds. Hour blinks 3 Adjust the hour. Hour entered []: sets the hour ahead. []: sets the hour back. 4 Press [DISP]. Minute blinks 5 Adjust the minute. Minute entered []: sets the minute ahead. []: sets the minute back. 6 Press [DISP]. Completed Notes: • "ADJUST" is displayed before adjusting the clock. • Hold down [] or [] to change numbers rapidly. • When "NO DISC" is displayed, the clock cannot be adjusted. Clock Display at Power Off Press [DISP] to change the display. Display off - 13 - Clock display (Default) Clock Setting