Panasonic SA-XR57K Receiver - Page 11

• Turn off all components before making any connections. • Peripheral equipment and cables sold separately unless otherwise indicated. • To connect equipment, refer to the appropriate operating instructions. Speaker impedance Front A: 6 to 8 Ω Center: 6 to 8 Ω Surround: 6 to 8 Ω Surround back: 6 to 8 Ω Use the terminal for the left speaker when you connect one surround back speaker only. Front speakers Surround speakers (R) (L) (R) (L) Center speaker Surround back speakers (R) (L) Home Theater connections Connections The unit's rear view Speaker cable GND LOOP EXT LOOP ANT GND FM ANT DIGITAL IN AM ANT OUT S VIDEO (DVD RECORDER) IN VIDEO FRONT A FRONT B R LF L BI-WIRE R HF L CENTER SURROUND R L SURROUND BACK R L (TV/STB) (DVD RECORDER) (DVD PLAYER) (CD) OPTICAL1 OPTICAL2 COAXIAL1 COAXIAL2 DIGITAL TRANSCEIVER SURROUND CHANNEL OUT IN IN IN OUT IN IN IN TV MONITOR DVD PLAYER DVD RECORDER TV/STB TV MONITOR DVD PLAYER DVD RECORDER VCR CENTER L IN TV/STB SPEAKERS HAUT-PARLEURS Y PB PR Y PB PR Y PB PR R IN CD SUBWOOFER SURROUND FRONT IN DVD/DVD 6CH IN DVD RECORDER AUDIO IN VCR IN OUT TV/STB SUBWOOFER TV MONITOR OUT DVD RECORDER IN COMPONENT VIDEO TV / STB IN Monaural connection cable AC power supply cord (included) Active subwoofer Household AC outlet (AC 120 V, 60 Hz) Connect AC power supply cord after all other cables and cords are connected. • The included AC power supply cord is for use with this unit only. Do not use it with other equipment. • Do not use an AC power supply cord from any other type of equipment with this unit. • If the unit is left unplugged for longer than two weeks, all settings will revert to the factory settings. Perform the settings again if this occurs. Note Do not forget to take steps instructed in "Detecting speakers automatically" (á page 14) after connecting a new speaker or making a similar change. Connecting speakers designed for bi-wiring Speakers designed for bi-wiring have separate connection terminals for high frequency and low frequency signals. • Bi-wiring prevents high frequency and low frequency signals from interfering with each other. It offers playback in high audio quality. • Different amplifiers for high frequency and low frequency signals produce bi-amp stereo sounds that are clearer and higher in audio quality when you play sources containing analog audio and 2-channel PCM signals (á page 18). • HF and LF stand for high frequencies and low frequencies, respectively. The unit's rear view HF Front speaker (R) Rear view LF Speaker impedance BI-WIRE: 6 to 8 Ω FRONT A FRONT B R LF L BI-WIRE R HF L CENTER SURROUND R L SURROUND BACK R L VIDEO IN IN IN IN DVD PLAYER DVD RECORDER VCR TV/STB FRONT IN IN VD 6CH IN DVD RECORDER VCR AUDIO IN OUT TV/STB SUBWOOFER SPEAKERS HAUT-PARLEURS Y PB PR Y PB PR Y PB PR TV MONITOR OUT DVD RECORDER IN COMPONENT VIDEO TV / STB IN HF LF Front speaker (L) Rear view Speaker cable Note • Make sure to connect speakers' HF terminals with the unit's FRONT B terminals, and speakers' LF terminals with the unit's FRONT A terminals. "Correcting the HF and LF difference" (á page 32) becomes unavailable when you make reverse connections. • Make sure to select "YES " in "Setting bi-wiring connections" (á page 31) when you connect the unit to speakers designed for biwiring. The speakers do not produce adequate sounds unless you make this setting. 11 RQT8549