Panasonic SAHT700 SAHT690 User Guide - Page 10

4 STEP Connecting the subwoofer, antennas, and AC power supply cord System cable AM loop antenna FM indoor antenna AC power supply cord [For\U.S.A.\and\Canada] [For\others] Power plug adaptor [For\areas\except\U.S.A.\and\Canada] Simple setup RQT6750 10 Connect the AC power supply cord after all other connections are complete. FM indoor antenna Adhesive tape Fix the other end of the antenna where reception is best. Click! AM loop antenna Stand the antenna up on its base. Keep loose antenna cord away from other wires and cords. Subwoofer [For\areas\except\U.S.A.\and\Canada] Before connecting the AC power supply cord Set the voltage. (Back of subwoofer) 2 75h GND LOOP EXT FM ANT AM ANT OPTICAL IN A TV VCR AUDIO AUDIO AUX IN IN LINE OUT L VIDEO OUT R S-VIDEO OUT 1 COMPO VIDEO PR PB Catch up To disconnect Press the catch and pull out. L1 R2 L3 R4 System cable 5 A Catch to the right To disconnect Press the catch Conserving power and pull out. The unit consumes power (For U.S.A. and Canada: approx. 0.5 W or for units with PX printed on the outer packaging and Latin America: approx. 0.9 W) even when it is turned off with [Í]. To save power when the unit is not to be used for a long time, unplug it from the household AC outlet. Remember to reset the radio stations and any other memory items before using the unit again. Information you enter into the unit's memory remains intact for up to 2 weeks after the AC power supply cord is disconnected. 127 V 110 V 220 V-230 V 240 V VOLT ADJ Use a flat-head screwdriver to turn the voltage selector on the back of the subwoofer to the appropriate position for the area in which this system is used. If the power supply in your area is 115 V or 120 V, please set the voltage selector as follows: ≥For 115 V: Set to 110 V. ≥For 120 V: Set to 127 V. AC power supply cord To household AC outlet [For\areas\except\U.S.A.\and\Canada] If the power plug will not fit your AC outlet Use the power plug adaptor (included). If it still doesn't fit, contact an electrical parts distributor for assistance. 5 STEP The remote control Remote control R6/LR6, AA, UM-3 +- 3 1 3 -+ 2 Batteries Do not; ≥mix old and new batteries. ≥use different types at the same time. ≥heat or expose to flame. ≥take apart or short circuit. ≥attempt to recharge alkaline or manganese batteries. ≥use batteries if the covering has been peeled off. Mishandling of batteries can cause electrolyte leakage which can damage items the fluid contacts and may cause a fire. Remove if the remote control is not going to be used for a long ≥Insert so the poles (i and period of time. Store in a cool, dark place. j) match those in the ∫ Use remote control. Aim at the sensor, avoiding obstacles, at a maximum range of ≥Do not use rechargeable 7 m (23 feet) directly in front of the unit. type batteries.