Panasonic SAHTB10 SAHTB10 User Guide - Page 17
Remote control code
View all Panasonic SAHTB10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
If the " D/DTS" indicator is blinking, unplug the AC power supply cord and consult your dealer. If the "TV, BD/DVD" indicator is blinking, try the following to correct the problem. Consult your dealer if the problem persists. ≥ Turn the connected device off and on again. ≥ Turn this unit off and reconnect the HDMI cables and then turn this unit on again. If this unit is connected to a non-Panasonic ARC compatible TV, connect using an optical digital audio cable. (> 10) ≥ After connecting the optical digital audio cable, the setting of this unit must be changed to specify the audio input terminal. (> right, "TV Audio") Audio is output from the TV speakers and not this unit's. ≥ When connected to a VIERA Link (HDAVI Control) compatible TV, change the audio output settings to this unit. (> 14) Changing this unit's settings Refer to "Troubleshooting" (> 16) before changing any of the following settings. The settings remain intact even if you switch the unit to standby mode. A will blink green once when the setting is changed. A Set "VIERA Link" to "On". Press and hold [INPUT SELECTOR] on this unit and [SOUND EFFECT] on the remote control for more than 2 sec. ∫ TV Audio Set "TV Audio" to "ARC Off". Set "TV Audio" to "ARC Off" only when using an optical digital audio cable with an ARC compatible TV. (> 16, "Sound") Press and hold [INPUT SELECTOR] on this unit and [TV] on the remote control for more than 2 sec. Set "TV Audio" to "Auto". Press and hold [INPUT SELECTOR] on this unit and [CLEAR-MODE DIALOG] on the remote control for more than 2 sec. Remote control code When other Panasonic products respond to this unit's remote control, change the remote control code on this unit and the remote control. Preparation ≥ Turn off all other Panasonic products. ≥ Turn on this unit. Change the remote control to code 2: 1 Aim the remote control at this unit's remote control sensor. 2 Press and hold [CLEAR-MODE DIALOG] and [BD/DVD] on the remote control for more than 4 sec. A Operating Instructions ∫ VIERA Link Changes to this setting become effective after turning off and on all the connected devices. Set "VIERA Link" to "Off". Set "VIERA Link" to "Off" when you do not want to use "HDAVI Control". (> 16, "General operation") Press and hold [INPUT SELECTOR] on this unit and [BD/DVD] on the remote control for more than 2 sec. ≥ When set to "Off", the ARC function is not available. Be sure to connect using the optical digital audio cable. (> 10) A will blink green once when the code of this unit is changed. ≥ If the unit does not operate after changing the code, repeat steps 1 and 2. ≥ To change the remote control to code 1, repeat the steps above, but replace [BD/DVD] with [TV]. 17