Panasonic SC-HC200 Owners Manual - Page 10

To check the setting Press [SETUP] repeatedly to select "TIMER ADJ" and then press [OK]. In standby mode, press [DISPLAY] two times. Note: • The timer starts at a low volume and increases gradually to the preset level. • The timer comes on at the set time every day if the timer is on. • If you turn off the system and then turn on again while a timer is in operation, the timer will not stop at the end time. • "CD", "USB" and "FM" can be set as the music source. Sound effects 1 Press [SOUND] repeatedly to select the sound effect. 2 Press [R, T] to select the setting and then press [OK]. MY SOUND PRESET EQ BASS TREBLE D.BASS SURROUND "SOUND 1", "SOUND 2" or "SOUND 3" (~below) "HEAVY", "SOFT", "CLEAR", "VOCAL" or "FLAT" -4 to +4 -4 to +4 "ON D.BASS" or "OFF D.BASS" "ON SURROUND" or "OFF SURROUND" Note: Changed settings will be kept until it is changed again, unless otherwise indicated. Saving the sound settings You can save the current sound effects (up to 3 combinations). Preparation Select the sound effects. 1 Press [SETUP] to select "SAVE MY SOUND". 2 Press [R, T] to select a sound setting number and then press [OK]. "SAVED" is shown. The new setting replaces the one existing in the same sound setting number. To recall the setting 1 Press [SOUND] to select "MY SOUND". 2 Press [R, T] to select the sound setting number and then press [OK]. Others Auto off This system automatically turns off when you do not use it for approximately 20 minutes. 1 Press [SETUP] repeatedly to select "AUTO OFF". 2 Press [R, T] to select "ON" and then press [OK]. To cancel, select "OFF". Note: This function does not work when you are in radio source or when a Bluetooth® device is connected. Bluetooth® standby This function automatically turns on the system when you establish a Bluetooth® connection from a paired device. 1 Press [SETUP] repeatedly to select "BLUETOOTH STANDBY". 2 Press [R, T] to select "ON" and then press [OK]. To cancel, select "OFF". Software update Occasionally, Panasonic may release updated software for this unit that may add or improve the way a feature operates. These updates are available free of charge. For more details, refer to the following website. http://panasonic.jp/support/global/cs/ (This site is in English only.) █ Checking the software version 1 Press [SETUP] repeatedly to select "SW VER." and then press [OK]. The software version is shown. 2 Press [OK] again to exit. TQBJ2156 10