Panasonic SC-HC200 Owners Manual - Page 9

ENGLISH █ Selecting a preset station 1 Press [PLAY MENU] repeatedly to select "TUNE MODE". 2 Press [R, T] to select "PRESET" and then press [OK]. 3 Press [2/3] or [5/6] to select the preset station. Improving the sound quality 1 Press [PLAY MENU] repeatedly to select "FM MODE". 2 Press [R, T] to select "MONO" and then press [OK]. To cancel, select "STEREO". "MONO" is also canceled when you change the frequency. To memorize the setting Continue with step 4 of "Manual presetting". (~8) Checking the signal status Press [DISPLAY]. FM - - - - FM ST FM MONO The FM signal is in monaural. The system is not tuned in to a station. The FM signal is in stereo. "MONO" is selected as the "FM MODE". FM allocation setting This system can also receive FM broadcasts allocated in 0.1 MHz steps. 1 Press [RADIO] to select "FM". 2 Press and hold [8] on the main unit. After a few seconds, the display panel shows the current minimum radio frequency. Release the button when the minimum frequency changes. • To go back to the initial setting, do the above steps again. • Preset frequencies are erased after you change the setting. Clock and timers Setting the clock This is a 12-hour clock. 1 Press [SETUP] repeatedly to select "CLOCK". 2 Press [R, T] to set the time and then press [OK]. To check the time Press [SETUP] repeatedly to select "CLOCK" and then press [OK]. In standby mode, press [DISPLAY]. Note: Reset the clock regularly to maintain accuracy. Sleep timer The sleep timer turns off the system after the set time. 1 Press [SETUP] repeatedly to select "SLEEP". 2 Press [R, T] to select the setting (in minutes) and then press [OK]. To cancel, select "OFF". Note: • The remaining time is shown at every minute except when other operations are being performed. "SLEEP 1" will always be shown when only 1 minute remains. • The sleep timer always comes first. Be sure not to set an overlap of timers. Play timer You can set the timer to come on at a certain time to wake you up. Preparation Set the clock. 1 Press [SETUP] repeatedly to select "TIMER ADJ". 2 Press [R, T] to set the start time and then press [OK]. 3 Repeat step 2 to set the end time. 4 Press [R, T] to select the music source you want to play and then press [OK]. To start the timer 1 Press [SETUP] repeatedly to select "TIMER SET". 2 Press [R, T] to select "SET" and then press [OK]. "#" is shown. To cancel, select "OFF". The system must be turned off for the timer to operate. TQBJ2156 9