Panasonic SC-HTE180 Owners Manual - Page 12
Setup Menu
View all Panasonic SC-HTE180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
AGC Auto gain control prevents sudden loud sound by reducing the sound level automatically when the input is too high. ON OFF LOW VOL MODE Enhance the dialog in low volume condition. ON OFF Select "OFF" to cancel this effect if the dialog does not sound natural in low volume condition. Note: The default setting is underlined. Changed settings will be kept until it is changed again, unless otherwise indicated. Audio format You can view the current audio format. Press and hold [SOUND] for a minimum of 4 seconds. DOLBY DIGITAL DTS PCM MULTI PCM ANALOG SBC Dolby Digital is the audio source. DTS is the audio source. Linear pulse-code modulation is the audio source. 2 channel pulse-code modulation is the audio source. Analog is the audio source. Sub-band Coding is the audio source. (Bluetooth® mode only.) Setup Menu 1 Press [SETUP] repeatedly to select the setup item. 2 Press [R, T] repeatedly to select the desired setting and then press [OK]. DIMMER AUTO POWER DOWN VOL LIMITATION BLUETOOTH STANDBY LINK MODE VIERA LINK Dims the display panel after 5 seconds of inactivity. ON OFF The system automatically turns off if there is no audio input and when you do not use it for 20 minutes. ON OFF Sets the volume limit to 50 when you turn on the system although the volume is set to above 50 before it is turned off. ON OFF This function allows you to connect a paired Bluetooth® device when this system is in standby mode. ON OFF The system will turn on automatically when you connect a paired Bluetooth® device. Change the Bluetooth® connection link mode to suit the connection type. Make sure to disconnect the current connected device ("BLUETOOTH READY" is shown). MODE 1: Emphasis on connectivity. MODE 2: Emphasis on sound quality. Turn on the VIERA Link function. ON OFF Select "OFF" when your HDAVI Control device does not work correctly with this system. ARC will be disabled. Connect an optical digital audio cable. Turn off all connected devices and then turn them on again after changing the setting. Note: The default setting is underlined. Changed settings will be kept until it is changed again, unless otherwise indicated. RQT9964 12