Panasonic SC-HTE180 Owners Manual - Page 15

ENGLISH █ Main unit displays "F61" • There is a problem with the amplifier of the system. • Disconnect the AC power supply cord and consult the dealer. "F70 HDMI" • Check HDMI connection. • Turn off the system and then turn it on again. • Disconnect the HDMI cable. "F76" • There is a problem with the power supply. • Disconnect the AC power supply cord and consult the dealer. System memory reset Reset the memory when the following situations occur: • There is no response when buttons are pressed. • You want to clear and reset the memory contents. 1 While the system is turned on, press and hold [1] on the main unit for a minimum of 4 seconds. "RESET" is shown. 2 Release [1]. 3 Turn off the system and then turn it on again. All the settings are reset to the factory defaults. Note: The remote control code will set back to "REMOTE 1" after memory reset, refer "Remote control code" on how to change to "REMOTE 2". Remote control code When other Panasonic equipment responds to the remote control of this system, change the remote control code for this system. Preparation • Turn off all other Panasonic products. • Turn on this system. • Aim the remote control at the remote control sensor of this system. █ To set the code to "REMOTE 2" Press and hold [MUTE] and [OK] for a minimum of 4 seconds. "REMOTE 2" is shown. █ To set the code to "REMOTE 1" Press and hold [MUTE] and [T] for a minimum of 4 seconds. "REMOTE 1" is shown. RQT9964 15