Panasonic SC-PM250 Owners Manual - Page 10
Clock and timers - bluetooth reset
![]() |
View all Panasonic SC-PM250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
█ Selecting a preset station 1 Press [PLAY MENU] repeatedly to select "TUNEMODE". 2 Press [R, T] to select "PRESET" and then press [OK]. 3 Press [2/3] or [5/6] to select the preset station. Improving the sound quality 1 Press [PLAY MENU] repeatedly to select "FM MODE". 2 Press [R, T] to select "MONO" and then press [OK]. To cancel, select "STEREO". "MONO" is also canceled when you change the frequency. To memorize the setting Continue with step 4 of "Manual presetting". Checking the signal status Press [DISPLAY]. FM - - - - FM ST FM MONO The FM signal is in monaural. The system is not tuned in to a station. The FM signal is in stereo. "MONO" is selected as the "FM MODE". FM allocation setting This system can also receive FM broadcasts allocated in 0.1 MHz steps. 1 Press [RADIO]. 2 Press and hold [SELECTOR] on the main unit. After a few seconds, the display panel shows the current minimum radio frequency. Release the button when the minimum frequency changes. • To go back to the initial setting, do the above steps again. • Preset frequencies are erased after you change the setting. Clock and timers Setting the clock This is a 12-hour clock. 1 Press [SETUP] repeatedly to select "CLOCK". 2 Press [R, T] to set the time and then press [OK]. To check the time Press [SETUP] repeatedly to select "CLOCK" and then press [OK]. In standby mode, press [DISPLAY]. Note: Reset the clock regularly to maintain accuracy. Play timer (Except for Bluetooth® source) You can set the timer to come on at a certain time to wake you up. Preparation Set the clock. 1 Press [SETUP] repeatedly to select "TIMER ADJ". 2 Press [R, T] to set the start time and then press [OK]. 3 Do step 2 again to set the end time. 4 Press [R, T] to select the source you want to play and then press [OK]. To start the timer 1 Press [SETUP] repeatedly to select "TIMER SET". 2 Press [R, T] to select "SET" and then press [OK]. "#" is shown. To cancel, select "OFF". The system must be switched off for the timer to operate. To check the setting Press [SETUP] repeatedly to select "TIMER ADJ" and then press [OK]. In standby mode, press [DISPLAY] two times. Note: • The timer starts at a low volume and increases gradually to the preset level. • The timer comes on at the set time every day if the timer is on. • If you switch off the system and then switch on again while a timer is in operation, the timer will not stop at the end time. RQT0A12 10
![](/manual_guide/products/panasonic-scpm250-owners-manual-dcfca5d/10.png)