Panasonic SC-PM250 Owners Manual - Page 7

ENGLISH Preparing the media Disc 1 Press [CD x] (main unit: [x OPEN/CLOSE]) to open the disc tray. Put in a disc with the label facing up. Press again to close the disc tray. 2 Press [USB/CD] to select "CD". USB 1 Reduce the volume and connect the USB device to the USB port. Hold the main unit when connecting or disconnecting the USB device. USB device (not supplied) 2 Press [USB/CD] to select "USB". Note: Do not use a USB extension cable. The system cannot recognize USB device connected through a cable. Bluetooth® You can connect and play an audio device wirelessly through Bluetooth®. Preparation • Switch on the Bluetooth® feature of the device and put the device near the system. • Read the operating instructions of the device for details. █ Pairing a device Preparation If this system is connected to a Bluetooth® device, disconnect it (Z"Disconnecting a device"). 1 Press [ ]. If "PAIRING" is shown, continue with step 4. 2 Press [PLAY MENU] to select "PAIRING". Or press and hold [ -PAIRING] on the main unit until "PAIRING" is shown. Continue with step 4. 3 Press [R, T] to select "OK? YES" and then press [OK]. "PAIRING" is shown. To cancel, select "OK? NO". 4 Select "SC-PM250" from the Bluetooth® menu of the device. If prompted for a passkey, input "0000". The device connects with this system automatically after pairing is complete. The name of the connected device is shown for a few seconds. Note: You can pair up to 8 devices with this system. If a 9th device is paired, the device that has not been used for the longest time will be replaced. █ Connecting a device Preparation If this system is connected to a Bluetooth® device, disconnect it (Z"Disconnecting a device"). 1 Press [ ]. "BLUETOOTH READY" is shown. 2 Select "SC-PM250" from the Bluetooth® menu of the device. The name of the connected device is shown for a few seconds. 3 Start playback on the device. Note: • A device must be paired to connect. • This system can only connect to one device at a time. • When "BLUETOOTH" is selected as the source, this system will automatically try to connect to the last connected device. █ Disconnecting a device 1 Press [ ]. 2 Press [PLAY MENU] repeatedly to select "DISCONNECT?". 3 Press [R, T] to select "OK? YES" and then press [OK]. "BLUETOOTH READY" is shown. To cancel, select "OK? NO". Using the main unit Press and hold [ -PAIRING] until "PAIRING" is shown. Note: A device is disconnected when you: • Select a different source. • Move the device out of the maximum range. • Disable the Bluetooth® transmission of the device. • Switch off the system or the device. RQT0A12 7