Panasonic SC-PMX70 Owners Manual - Page 3

Maintenance, Supplied accessories, Preparing the remote control, Placement of speakers

Page 3 highlights

This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment and meets the RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that is deemed to comply without maximum permissive exposure evaluation (MPE). But it is desirable that it should be installed and operated keeping the radiator at least 20 cm (7 7/8q) or more away from person's body (excluding extremities: hands, wrists, feet and ankles). This device complies with RSS-210 of the IC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, (2) This device must accept any interference received, including interference that may cause undesired operation of this device. CAN ICES-3(B)/NMB-3(B) The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance. Maintenance • To clean this system, wipe with a soft, dry cloth. • Never use alcohol, paint thinner or benzine to clean this system. • Before using chemically treated cloth, read the instructions that came with the cloth carefully. Supplied accessories Check and identify the supplied accessories. ∏ 1 x AC power supply ∏ 1 x Remote control cord (N2QAYB001018) (K2CB2CB00022) ∏ 1 x FM indoor antenna (RSAX0002) ∏ 1 x Remote control battery Placement of speakers Tweeter ∏ 2 x Speaker cables (REE1713) • The enclosed Canadian French label sheet corresponds to the English display on the front and rear of the main unit. • Product numbers provided in this Owner's Manual are correct as of January 2015. These may be subject to change. Preparing the remote control Place the speakers so that the tweeter is on the inner side. To prevent damage to the speakers, do not touch the speaker cones if you remove the nets. Use only the supplied speakers. The combination of the main unit and speakers give the best sound. You can cause damage to the system and decrease the sound quality if you use other speakers. Note: • Keep your speakers more than 10 mm (13/32q) from the main unit for ventilation. • Put the speakers on a flat safe surface. • These speakers do not have magnetic shielding. Do not put them near TVs, PCs or other equipment easily influenced by magnetism. • When you play at high levels for a long period, it can cause damage to the system and decrease the life of the system. • Decrease the volume in these conditions to prevent damage: - When you play distorted sound. - When you adjust the sound quality. R6/LR6, AA • Use alkaline or manganese battery. • Install the battery so that the poles (+ and -) align with those in the remote control. • Point the remote control at the remote control sensor, away from obstacles, at a maximum range of 7 m (23 ft) directly in front of the main unit, within an angle of approximately 30° to the left and right. CAUTION! • Use the speakers only with the recommended system. If not, you can cause damage to the amplifier and speakers and can cause a fire. Consult an approved service personnel if damage occurs or if there is a sudden apparent change in performance. • Do the procedures included in these instructions when you attach the speakers. 3 RQT9989

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

3
RQT9989
Maintenance
To clean this system, wipe with a soft, dry cloth.
Never use alcohol, paint thinner or benzine to clean
this system.
Before using chemically treated cloth, read the
instructions that came with the cloth carefully.
Supplied accessories
Check and identify the supplied accessories.
The enclosed Canadian French label sheet
corresponds to the English display on the front and
rear of the main unit.
Product numbers provided in this Owner’s Manual are
correct as of January 2015. These may be subject to
change.
Preparing the remote control
Use alkaline or manganese battery.
Install the battery so that the poles (+ and –) align with
those in the remote control.
Point the remote control at the remote control sensor,
away from obstacles, at a maximum range of
7 m (23 ft) directly in front of the main unit, within an
angle of approximately 30° to the left and right.
Placement of speakers
Place the speakers so that the tweeter is on the inner
side. To prevent damage to the speakers, do not touch
the speaker cones if you remove the nets.
Use only the supplied speakers.
The combination of the main unit and speakers give the
best sound. You can cause damage to the system and
decrease the sound quality if you use other speakers.
Note:
Keep your speakers more than 10 mm (
13
/
32
q
) from the main
unit for ventilation.
Put the speakers on a flat safe surface.
These speakers do not have magnetic shielding. Do not
put them near TVs, PCs or other equipment easily
influenced by magnetism.
When you play at high levels for a long period, it can cause
damage to the system and decrease the life of the system.
Decrease the volume in these conditions to prevent
damage:
-
When you play distorted sound.
-
When you adjust the sound quality.
This transmitter must not be co-located or operated
in conjunction with any other antenna or transmitter.
This equipment complies with IC radiation exposure
limits set forth for an uncontrolled environment and
meets the RSS-102 of the IC radio frequency (RF)
Exposure rules. This equipment has very low levels
of RF energy that is deemed to comply without
maximum permissive exposure evaluation (MPE).
But it is desirable that it should be installed and
operated keeping the radiator at least 20 cm (7
7
/
8
q
)
or more away from person’s body (excluding
extremities: hands, wrists, feet and ankles).
This device complies with RSS-210 of the IC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
(2) This device must accept any interference
received, including interference that may cause
undesired operation of this device.
CAN ICES-3(B)/NMB-3(B)
The device meets the exemption from the routine
evaluation limits in section 2.5 of RSS 102 and
compliance with RSS-102 RF exposure, users can
obtain Canadian information on RF exposure and
compliance.
1 x AC power supply
cord
(
K2CB2CB00022
)
1 x Remote control
(N2QAYB001018)
1 x FM indoor
antenna
(
RSAX0002
)
1 x Remote control
battery
2 x Speaker cables
(
REE1713
)
R6/LR6, AA
CAUTION!
Use the speakers only with the recommended
system. If not, you can cause damage to the
amplifier and speakers and can cause a fire.
Consult an approved service personnel if damage
occurs or if there is a sudden apparent change in
performance.
Do the procedures included in these instructions
when you attach the speakers.
Tweeter