Panasonic SCBTT770 SCBTT270 User Guide - Page 11
Preparing cables and making connection, wire fully, taking care not to insert beyond
UPC - 885170029842
View all Panasonic SCBTT770 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Getting started [BTT370] [BTT273] Thread the speaker cable through the base. ≥ Use cables with a white connector and red connector. Leave about 110 mm (4 11/32q) Tighten securely. Insert the wire fully. r: White s: Blue line Push! Press into the groove. Pull the cable straight along the line and slide into the groove. Back of the base Preparing cables and making connection 1 Use of the speaker cable stickers is convenient when making cable connections. e.g. Front speaker (L) FRONT Lch A Speaker cable sticker (supplied) B Connector Speaker cable sticker 1 FRONT (L) 2 FRONT (R) 3 SURROUND (L) 4 SURROUND (R) 5 CENTER 6 SUBWOOFER Color WHITE RED BLUE GRAY GREEN PURPLE Be sure to match the number on each sticker with the connector color. 2 Connecting the speaker cables. Insert the wire fully, taking care not to insert beyond the wire insulation. ≥ [BTT770] Be sure to use the speaker cables that have a large connector and short cable when you use the wireless system. e.g. Surround speaker r: White s: Blue line Push! ≥ Be careful not to cross (short-circuit) or reverse the polarity of the speaker wires as doing so may damage the speakers. ≥ Don't use a front speaker as a surround speaker or vice versa. Verify the type of speaker with the label on the rear of the speaker before connecting the appropriate cable. ≥ To avoid injury by falling or dropping the speaker, place the speaker cables with care not to stumble or hook. ≥ Do not hold the speaker in one hand to avoid injury by dropping the speaker when carrying. [BTT770] [BTT370] [BTT273] ∫ Preventing the speakers from falling ≥ Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that may not have strong enough support. Improper attachment may result in damage to the wall or speakers. ≥ Use a string of less than ‰ 2.0 mm (3/32q), which is capable of supporting over 10 kg (22 lbs). e.g., [BTT770] A String (not supplied) Thread from the wall to the speaker and tie tightly. B Rear of the speaker C Screw eye (not supplied) D Wall E Approx.150 mm (5 29/32q) VQT3D27 11