Panasonic SCHC38 SCHC38 User Guide - Page 11
Others, Troubleshooting - phones
View all Panasonic SCHC38 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
ENGLISH Others Automatic standby As a factory preset, this unit will always turn off automatically if there is no sound output and no operation for approx. 30 minutes. To cancel this function 1 Press [SETUP] repeatedly to select "AUTO OFF". 2 Press [3, 4] to select "OFF" and then press [OK]. ≥ To turn automatic standby on, select "ON" in step 2. ≥ This setting cannot be selected when "FM" is the source. Display brightness The brightness of this unit's display can be changed. 1 Press [SETUP] repeatedly to select "DIMMER". 2 Press [3, 4] to select "ON" and then press [OK]. Troubleshooting Before requesting service, make the following checks. If you are in doubt about some of the check points, or if the solutions indicated in the following guide do not solve the problem, refer to "Customer Services Directory (United States and Puerto Rico)" on page 19. To return all settings to the factory preset When the following situations occur, reset the memory: ≥ There is no response when buttons are pressed. ≥ You want to clear and reset the memory contents. 1 Disconnect the AC power supply cord. (Wait for at least 3 minutes before proceeding to step 2.) 2 While pressing and holding down [Í/I] on the unit, reconnect the AC power supply cord appears on the display. 3 Release [Í/I]. All the settings are returned to the factory preset. You will need to reset the memory items. Common problems To cancel the dimmer, select "OFF" in step 2. Changing the unit and remote control code When other Panasonic equipment responds to the supplied remote control, change the remote control code. 1 Press [CD] to select "CD". 2 While pressing and holding [SELECTOR] on the unit, press and hold [CD/RADIO] on the remote control until the unit's display shows "REMOTE 2". 3 Press and hold [OK] and [CD/RADIO] on the remote control for at least 4 seconds. ≥ To change the mode back to "REMOTE 1", repeat the steps above but replace the button pressed on the remote control from [CD/RADIO] to [ ]. Humming heard during play. ≥ An AC power supply cord or fluorescent light is near the cords. Keep other appliances and cords away from this unit's cables. Disc operations Incorrect display or play will not start. ≥ Make sure that the disc is compatible with this unit. (l 14) ≥ There is moisture on the lens. Wait for about an hour and then try again. Radio A beat sound or noise is heard while receiving radio broadcast. ≥ Confirm the FM antenna is properly connected. (l 5) ≥ Adjust the position of the antenna. ≥ Try to keep a certain amount of distance between the antenna and AC power supply cord. ≥ Try using an outdoor antenna if there are buildings or mountains nearby. ≥ Switch the television or other audio players off or separate it from this unit. ≥ Keep this unit away from mobile phones if the interference is apparent. 11 RQT9742