Panasonic SCHTB170 SCHTB170 User Guide - Page 17

Getting started Using the IR Blaster With the IR Blaster connection, it is possible to send the IR signal received by this system's remote control signal sensor to the TV's sensor. Use the TV's remote control within the operation range of this system's remote control signal sensor. ≥For the operation range, refer to page 7. Connect the jack plug to the main unit's Ir SYSTEM terminal. A Infrared emitter  Ir SYSTEM Place the infrared emitter in sight of the TV's remote control signal sensor. ≥For the location of the TV's remote control signal sensor, refer to the operating instructions for the TV. Aim the TV's remote control at this system's remote control sensor and operate the TV. ≥For the location of this system's remote control signal sensor, refer to page 6. ≥Make sure to clean the surface, where the adhesive tape is to be attached. ≥If you peel off the adhesive tape, the surface may become damaged and exposed adhesive may remain. Once you have confirmed the TV is operating correctly, secure it by attaching the adhesive tape. ≥ The supplied IR Blaster is only compatible with Panasonic TVs. ≥ Keep the adhesive tape out of reach of children to prevent swallowing. ∫ Placement example On the rear of the main unit: TV remote control signal sensor Adhesive tape (supplied) 17 RQT9841