Panasonic SCHTB170 SCHTB170 User Guide - Page 25

Others ∫ Remote control code When other Panasonic devices respond to this system's remote control, change the remote control code on this system and the remote control. Preparation ≥ Turn off all other Panasonic products. ≥ Turn on the main unit. Change the remote control code to code 2: 1 Aim the remote control at the main unit's remote control sensor. 2 Press and hold [MUTE] and [ ] on the remote control for more than 4 sec. ≥ All the indicators will blink for 10 sec when the code of this system is changed. ∫ To turn off VIERA Link "HDAVI Control" When "HDAVI Control" compatible equipment does not work well with this system, for example, it is possible to turn off this function as follows: ≥ When VIERA Link is turned off, the ARC function is not available. Be sure to connect the optical digital audio cable. (> 15) 1 While pressing and holding [MUTE] on the remote control, press and hold [s VOL] on the main unit for more than 4 sec. 2 After the setting has changed, turn off all the connected devices and then turn them on again. ≥ All the indicators will blink once when VIERA Link "HDAVI Control" is turned off. ≥ The setting is maintained until it is changed again. ≥ If the main unit does not operate after changing the code, repeat steps 1 and 2. ≥ To change the remote control code to code 1, repeat the steps above, but replace [ ] with [INPUT SELECTOR]. ∫ To reduce the clear-mode dialog effect When the dialog does not sound natural while the volume is set low, It is possible to reduce the dialog enhancing effect as follows: While pressing and holding [SOUND] on the remote control, press and hold [s VOL] on the main unit for more than 4 sec. ≥ All the indicators will blink once when the clear-mode dialog effect is reduced. To reset the setting, return to the factory preset. (> 26) ∫ To turn off the volume limitation If a state of the lowered volume disturbs you every time the main unit turns on, for example, it is possible to turn off this function as follows: While pressing and holding [MUTE] on the remote control, press and hold [VOL i] on the main unit for more than 4 sec. ≥ All the indicators will blink once when the volume limitation is turned off. ≥ Even if clear-mode dialog effect is reduced, dialog effect level is still adjustable. To reset the setting, return to the factory preset. (> 26) To reset the setting, return to the factory preset. (> 26) Operations 25 RQT9841