Panasonic SU-G700 Owners Manual - Page 31
When PRE OUT is set to On Speaker:Off
![]() |
View all Panasonic SU-G700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
English Sound is distorted. • Setting "Attenuator" to "On" according to the analog audio input may minimize the sound distortion. ( 18, 19, 21) • Setting the attenuator is not available for the output audio signal from LINE OUT terminal. The volume is automatically changed. • When the input source is switched to "LINE2" or other source from "MAIN IN" and the current volume level is higher than previous level, the volume is automatically adjusted. (Volume knob automatically turns.) ( 20) The unit turns to standby mode automatically. • Is the auto off function turned on? ( 25) • This unit incorporates a protection circuit to prevent damage caused by heat buildup. When you use this unit at a high volume level for a long period of time, it may turn off automatically. Wait for this unit to cool down before turning on this unit again. (For approximately 3 minutes) The settings are reset to the factory defaults. • Updating the firmware may reset the settings. The peak power meter does not operate. • In the following cases, this meter does not operate: - When the headphones are connected. - When the peak power meter light is turned off by pressing [DIMMER]. - When this unit is muted by pressing [MUTE]. - When "PRE OUT" is set to "On (Speaker:Off)" ( 22) The system control function is not working. • Use the system connection cable supplied with the connected device. • Connect the system connection cable to the system terminals (CONTROL). ( 28) • Check the connection of system connection cable, audio cable and the input source which is set with "System Control". ( 28) • Connect Technics device supporting system control function (Network Audio Player, Compact Disc Player, etc.) to this unit. For details, refer to the following website. www.technics.com/support/ PC The PC does not recognize this unit. • Check your operating environment. ( 17) • Restart the PC, turn this unit to standby and on, and then reconnect the USB cable. • Use another USB port of the connected PC. • Install the dedicated USB driver if using a PC with Windows. ( 17) Remote control The remote control does not work properly. • The batteries are depleted or inserted incorrectly. ( 12) • To avoid interference, please do not put any objects in front of signal sensor. ( 10) • If the remote control mode of the remote control differs from that of this unit, match the mode of the remote control to the mode of this unit. ( 13) Troubleshooting (31) 31
![](/manual_guide/products/panasonic-sug700-owners-manual-e0f92ba/31.png)