Panasonic TADA2420 TADA2420 User Guide - Page 10

8. Attach the antenna to the tilt slots on the clamp/mount assembly with two 1-3/4" long carriage bolts, flat washers and ESNA locknuts, making certain the center pin on the antenna is in the mating hole in mount tab before tightening. See Figure 5. FIGURE 5 FIGURE 5A 9. Make the PERMANENT TILT adjustment . Remember, this is the value listed for your site location which was determined from your satellite receiver menu screen. (Do not use numbers from any other sources.) Be sure both bolts in the slots are 1/3 turn loosened from tight during adjustment. After adjustment, securely tighten after the desired tilt scale number is aligned with the molded indicator line on the antenna. See Figure 5A.. IMPORTANT! DO NOT MAKE ANY FURTHER ADJUSTMENTS TO THIS TILT SETTING. FIGURE 6 FIGURE 6A 10. For models with fine tune adjustment, make the initial elevation adjustment from the value listed for your site loca- tion which was determined from your satellite receiver menu screen. Be sure both bolts in the slots are 1/3 turn loosened from tight. Adjust the elevation until the white painted clamp tab edge indicator aligns with the desired elevation value on scale. See Figures 6 and 6A.. 11. If fine elevation adjustment hardware is not included with your dish model, then adjust elevation as per Figure 6A. Tighten elevation bolts on both sides. -10-