Panasonic TADA2420 TADA2420 User Guide - Page 9
Critical Alignment
View all Panasonic TADA2420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
FIGURE 2 WOOD STRUCTURES Critical Alignment FIGURE 2A MASONRY STRUCTURES FIGURE 2B 3. On clamp/mount assembly, install (2 long azimuth clamp bolts and flange nuts as shown in Figure 3. Do not tighten at this time. 4. Install a 1/2" long carriage bolt through the square hole in the clamp tab and elevation adjustment slot. Capture with a flat washer and ESNA locknut. Tighten nut and then loosen 1/3 turn. See Figure 3. For units NOT equipped with fine elevation adjustment, skip to Step 7. 5. For Models equipped with Fine Elevation Adjustment Option: Assemble long fine tune elevation bolt to the Az/El mount elevation bracket with an embossed elevation scale using a 1/2" long carriage bolt and ESNA locknut. Tighten and then loosen 1/3 turn to allow bracket to pivot. See Figure 4. FIGURE 3 - Az/El Assembly - Opposite side of Figure 4 FIGURE 4 - Az/El Assembly - Optional Fine Elevation Adjust. 6. Thread the L-bracket onto the long fine elevation adjustment bolt approximately one inch. Then assemble the L-bracket to the elevation slot with a 1/2" long carriage bolt passing through the square hole in the clamp tab, elevation adjustment slot, and L-bracket. Capture all with an ESNA lock nut. Tighten nut and then loosen 1/3 turn. See Figure 4. 7. If the Fine Elevation bolt is not equipped on your model, install the second ¹⁄₂" long carriage bolt through square hole in the clamp tab, then through the elevation adjustment slot on side with embossed elevation scale and capture with a flat washer and ESNA locknut. Tighten nut and then loosen ¹⁄₃ turn. Similar to Figure 3. -9-