Panasonic TH-L32C10 User Manual - Page 48

Other HDMI Sound Screen FAQs Problem Chaotic image, noisy No image can be displayed Blurry or distorted image (no sound or low volume) Unusual image is displayed No sound is produced Sound level is low or sound is distorted Sound is unusual Pictures from external equipment are unusual when the equipment is connected via HDMI TV goes into "Standby mode" The remote control does not work 48 Actions Set "P-NR" in the Picture Menu (to remove noise). (p. 20) Check nearby electrical products (car, motorcycle, fluorescent lamp). Is "Colour" or "Contrast" in the Picture Menu set to the minimum? (p. 20) Check Colour System. (p. 27) Check AV Colour System. (p. 21) Reset channel. (p. 28) Turn off the TV with Mains power On / Off switch, then turn it on again. Is "Sound mute" active? (p. 8) Is the volume set to the minimum? Sound signal reception may be deteriorated. Check Sound system. (p. 27) Set "MPX" (p. 20) in the Sound Menu to "Mono". Set the sound setting of the connected equipment to "2ch L.PCM". Check the "HDMI1 Input" (or "HDMI Input" for TH-L32C12K) setting in the Sound Menu. (p. 20) If digital sound connection has a problem, select analogue sound connection. (p. 43) Is the HDMI cable connected properly? (p. 45) Turn Off the TV and equipment, then turn them On again. Check an input signal from the equipment. (p. 46) Use an equipment compliant with EIA/CEA-861/861B. Off Timer function is activated. The TV enters "Standby mode" about 30 min. after broadcasting ends. Are the batteries installed correctly? (p. 6) Has the TV been switched On? Has the battery run down?