Panasonic TH42PH10UKA 42" Plasma Television - Page 37

SET UP for Input Signals COLOR SYSTEM / Panasonic AUTO Select SIGNAL from the "SET UP" menu during VIDEO (S VIDEO) input signal mode.("SIGNAL [VIDEO]" menu is displayed.) Press to select the "COLOR SYSTEM" or "Panasonic AUTO". Press to select each function. If the image becomes unstable: With the system set on Auto, under conditions of low level or noisy input signals the image may in rare cases become unstable. Should this occur, set the system to match the format of the input signal. SET UP 1/2 SIGNAL COMPONENT/RGB-IN SELECT RGB INPUT LABEL PC POWER SAVE OFF STANDBY SAVE OFF POWER MANAGEMENT OFF AUTO POWER OFF OFF OSD LANGUAGE ENGLISH (US) Press ACTION ( ) button SIGNAL [ VIDEO ] 3D Y/C FILTER (NTSC) COLOR SYSTEM 3 : 2 PULLDOWN Panasonic AUTO (4 : 3) VIDEO NR ON AUTO OFF NORMAL OFF Mode COLOR SYSTEM Function Set the color system to match the input signal. When selecting "AUTO", the color system is automatically selected from NTSC/PAL/SECAM, however, M.NTSC signal is not displayed properly depending on the attached terminal board. To display M.NTSC signal, select "M.NTSC" in COLOR SYSTEM. AUTO PAL SECAM M.NTSC NTSC Panasonic AUTO Set to "NORMAL" to view 4:3 images in an unchanged format when Panasonic AUTO is (4 : 3 ) selected. If you would like to view 4:3 images in Just format, set to "JUST". Note: Panasonic AUTO does not function when BNC Dual Video Terminal Board (TY-FB9BD) is used. 3:2 PULLDOWN / VIDEO NR 3:2 PULLDOWN: When ON, the display attempts to reproduce a more natural interpretation of sources such as movie pictures, which are recorded at 24 frames per second. If the picture is not stable, turn the setting to OFF. SET UP 1/2 Notes: When ON, this setting only affects the following signal input: • NTSC / PAL signal input during "VIDEO (S VIDEO)" input signal. SIGNAL COMPONENT/RGB-IN SELECT RGB INPUT LABEL PC • 525i(480i), 625i(575i), 1125(1080)/60i signal input during "COMPONENT" input signal. POWER SAVE OFF STANDBY SAVE OFF VIDEO NR: Automatically reduces unwanted picture noise. Note: POWER MANAGEMENT OFF AUTO POWER OFF OFF OSD LANGUAGE ENGLISH (US) VIDEO NR cannot be adjusted while a PC signal is being applied. Press ACTION ( ) button 1 Press to select 3:2 PULLDOWN or VIDEO NR. SIGNAL 3D Y/C FILTER (NTSC) [ VIDEO ] ON SIGNAL SYNC [ RGB ] AUTO Press to set ON/OFF. COLOR SYSTEM AUTO 3 : 2 PULLDOWN OFF 3 : 2 PULLDOWN OFF VIDEO NR OFF Panasonic AUTO (4 : 3) VIDEO NR NORMAL OFF H-FREQ. 33.8 kHz V-FREQ. 60.0 Hz SIGNAL [ COMPONENT ] SIGNAL [ Digital ] 3 : 2 PULLDOWN OFF 3 : 2 PULLDOWN OFF VIDEO NR OFF VIDEO NR OFF 2 Press to exit from adjust mode. H-FREQ. 33.8 kHz V-FREQ. 60.0 Hz 37