Panasonic TX32LX70L TX26LX70L User Guide - Page 38
Screen, Sound, Other, Problem, Actions
View all Panasonic TX32LX70L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Screen FAQs Problem Chaotic image, noisy No image can be displayed Blurry or distorted image (no sound or low volume) Unusual image is displayed No sound is produced Sound level is low or sound is distorted Sound is unusual Sound HDMI 38 Other Pictures from external equipment are unusual when the equipment is connected via HDMI TV goes into "Standby mode" The remote control does not work An error message appears Actions ••Set "P-NR" in the Picture Menu (to remove noise). (p. 20) Check nearby electrical products (car, motorcycle, fluorescent lamp). Is "Colour" or "Contrast" in the Picture Menu set to the minimum? •(p. 20) •Check Colour system. (p. 23) •Reset channels. (p. 22) •Turn off the TV with Mains power On / Off switch, then turn it on again. ••Is "Sound mute" active? (p. 7) Is the volume set to the minimum? •••Sound signal reception may be deteriorated. Set "MPX" (p. 20) in the Sound Menu to "Mono". Check Sound system. (p. 23) Set the sound setting of the connected equipment to •"2ch L.PCM". Check the "HDMI1 Input" setting in the Sound Menu. (p. 20) •If digital sound connection has a problem, select analogue sound •connection. (p. 29) ••••Is the HDMI cable connected properly? (p. 32) Turn Off the TV and equipment, then turn them On again. Check an input signal from the equipment. (p. 36) Use an equipment compliant with EIA/CEA-861/861B. ••Off Timer function is activated. The TV enters "Standby mode" about 30 min. after broadcasting ends. ••Are the batteries installed correctly? (p. 6) Has the TV been switched On? ••Follow the message's instructions. If the problem persists, contact the authorized Service Centre.