Panasonic VDR D100 Dvd Camcorder-english/spanish - Page 24
SETUP, POWER SUPPLY, Charging the battery - dc cable
UPC - 037988980192
View all Panasonic VDR D100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Setup Power supply Power supply Charging the battery When this unit is purchased, the battery is not charged. Charge the battery before using this unit. ≥ If the DC cable is connected to the AC adaptor, then the battery will not charge. Remove the DC cable from the AC adaptor. 1 Connect the AC cable to the AC adaptor and the A AC outlet. 2 Put the battery on the battery mount by aligning the mark, and then securely plug it in. ≥ The output plug of the AC cable is not completely connected to the AC adaptor jack. As shown in A, there is a gap. ∫ Charging lamp Lights up: Charging Goes off: Charging completed Flashing: The battery is over discharged (discharged excessively). In a while, the lamp will light up and normal charging will start. When the battery temperature is excessively high or low, the CHARGE lamp flashes and the charging time will be longer than normal. ≥ Battery charging time (l 25) ≥ We recommend using Panasonic batteries. ≥ If you use other batteries, we cannot guarantee the quality of this product. Fitting the battery Push the battery against the battery holder and slide it until it clicks. Setup Removing the battery While sliding the BATTERY RELEASE lever, slide the battery to remove it. ≥ Hold the battery with your hand so it does not fall. 24 LSQT0969 ≥ Be sure to turn off the power on this unit and check that the status indicator and the access lamp are both off before removing the battery.