Panasonic WJ-ND400K Setup Information - Page 41
Command alarm, Command alarm settings
View all Panasonic WJ-ND400K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Event Command alarm Use the following procedure to configure settings that control command alarm action when an event occurs. 1 Click the [Event] button on the setup menu. 2 On the sub-menu that appears, click [Command alarm]. This will display the command alarm setting window. 3 Configure the settings for each item. Refer to "Command alarm settings" table for details about the settings. • To configure the settings of a command alarm that is not shown on the display, click the applicable command alarm number range above the [Set] button to change the contents of the display. • Clicking a command number saves the currently displayed command settings. 4 Click the [Set] button. Command alarm settings Item Rec. cam. Preset position Settings Cam.1 to Cam.64 / -Number input (Blank♦) Output terminal Off / On♦ ♦Initial default Description Specifies the channel of the recording camera. Specifies the preset position (1 to 256) during alarm input. • When this setting is blank, the camera does not move to a preset position. Specifies whether an alarm signal should be output when an event occurs. 41