Panasonic WVCU161C WVCU161C User Guide - Page 20

• Closing Setup Menu Press the PRESET/SET/PROGRAM PRESET button for 2 seconds or more while the SHIFT indicator is lit. The SETUP indicator goes off. Note: The new settings are not saved if the WVCU161C power is turned off before completing the setup. Return to the WV-CU161C SETUP MENU, complete the setup, and then turn the power off to save the new settings. s Alarm Setup Alarm related functions are set up. 1. Display the WV-CU161CC SETUP MENU. 2. Move the cursor to ALARM SETUP , and then press the SET button. The setup menu appears depending on the ALARM switch setting on the rear of the controller. ALARM PRESET appears on the bottom of the menu when the ALARM switch is set to the upper position to connect with a time lapse VCR. ALARM SETUP ALARM DISPLAY ON SITE ALARM ON TERM.ALARM ON ALARM OUTPUT 10S ALARM BUZZER ON ALARM PRESET - ALARM TERMINAL appears on the bottom of the menu when the ALARM switch is set to the lower position to connect with four sensors. ALARM SETUP ALARM DISPLAY ON SITE ALARM ON TERM.ALARM ON ALARM OUTPUT 10S ALARM BUZZER ON ALARM TERMINAL Alarm Display Setting This item lets you select whether or not to display an "ALARM" text line on the monitor when an alarm is activated. 1. Display the ALARM SETUP menu. 2. Move the cursor to ALARM DISPLAY. 3. Select ON or OFF using the joystick, and then press the SET button. The factory setting is ON. ON: Display is enabled. 20 OFF: Display is disabled. Note: The display time differs depending on the Alarm Output Setting. Site Alarm Setting This item lets you enable or disable the controller to receive the camera site alarm. 1. Display the ALARM SETUP menu. 2. Select SITE ALARM by moving the joystick up or down. 3. Select SITE ALARM ON or OFF by moving the joystick to the right or left. The initial factory setting is ON. ON: The controller receives the site alarm (Video Motion Detection: VMD) issued by the camera. OFF: The site alarm is disabled. Terminal Alarm Setting This item lets you enable or disable the controller to receive the alarm signal from the alarm connector. 1. Display the ALARM SETUP menu. 2. Select TERM.ALARM by moving the joystick up or down. 3. Select TERM.ALARM ON or OFF by moving the joystick to the right or left. The initial factory setting is ON. ON: Alarm activation through the terminal is received. OFF: Alarm activation through the terminal is no received. Alarm Output Setting This item lets you select the duration that the following three functions continue working for after an alarm activation. • The ALARM is displayed on the monitor (ALARM DISPLAY ON mode). • The alarm is output to external devices (from the ALARM OUTPUT connector). • The buzzer sounds (ALARM BUZZER ON mode). 1. Display the ALARM SETUP menu. 2. Select ALARM OUTPUT by moving the joystick up or down. 3. Select the desired alarm output duration of 1S-30S, 40S, 50S, 1MIN, 2MIN, 3MIN, 4MIN, 5MIN EXT or OFF by moving the joystick to the right or left. The initial factory setting is 10S. EXT: The alarm signal continues to be output from the alarm output connector until the alarm is reset. The alarm is not automatically reset. 1S-5MIN: The alarm signal is only supplied from the alarm output connector for the set time. The alarm is automatically reset after the set time. The ALARM indicator changes from blinking to a steady light. OFF: No alarm output signal is supplied. (The alarm is deactivated.)