Panasonic WVCU360C WVCU360C User Guide - Page 13
INSTALLATIONS (PS•Data), System Connections, Connection Example - wv cu360c
UPC - 791871503454
View all Panasonic WVCU360C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
INSTALLATIONS (PS•Data) CAUTION The installation should be made by qualified service personnel or system installers according to the following instructions. s System Connections q Connection Example Example 1 shows 8 cameras connected to 2 Data Multiplex Units (WJ-MP204C), to a Video Multiplexer (e.g., WJ-FS316) and a Digital Disk Recorder (e.g., WJ-HD100). The WV-CU360C controls these system units through RS-485 communication while pictures are viewed on the monitors. Camera No. 5 Camera No. 4 Camera No. 1 Camera No. 6 Camera No. 2 Camera No. 7 Camera No. 3 Camera No. 8 VS/VD INPUT VS/VD OUTPUT WJ-MP204C IN 4 3 2 OUT 4 3 2 CAMERA Unit Address 2 1 IN IN A L A R M / R E M OT E SD RD GB A B A 1 OUT OUT SPOT VS/VD RS485 DATA SIGNAL GND MODE IN 4 3 2 OUT 4 3 2 CAMERA MODE 4-Line Termination ON Panasonic Security Data mode Unit Address 1 1 IN IN A L A R M / R E M OT E T R GB A B A 1 OUT OUT SPOT VS/VD RS485 DATA SIGNAL GND MODE WJ-MP204C MODE VD OUT 4-Line Termination OFF Panasonic Security Data mode 13 78 78 (EXT REC) JOG-CLICK JOG-LEFT JOG-RIGHT G ALARM SEARCH STEP REW/FF STOP/SETUP PLAY REC G OUT IN PLAY OUT REC OUT AUTO OFF OUT DISK END OUT OUT IN G RECALL OUT RECOVER OUT RESET IN IN WJ-FS316 16 15 14 13 12 11 10 9 8 7 6 5 IN OUT 16 15 14 13 12 11 10 9 8 7 6 5 VIDEO PLAY Unit Address 3 4 3 2 1 ALARM/REMOTE SIGNAL DATA CAMERA SW IN GND 4 3 2 1 MULTI PLAY IN REC OUT SCREEN OUT SPOT OUT PLAY IN VIDEO IN REC OUT WJ-HD100 Up to four WV-CU360C can be used in a system. IN IN OUT AUDIO OUT CAMERA SW OUT VIDEO MONITOR OUT (PLAY) RS-232C DATA MODE REMOTE TIME ADJUST SERIES RECORD ALARM Branch Cable Unit Address 4 POWER ON SIGNAL GND OFF RS-485 Cable 6-conductor Modular Cable (supplied) 901 CONTROLLER No. MODE DATA DC 9V IN 456 456 23 23 Controller No. 1 901 Keep in OFF position Termination ON Set to OFF position (for operator mode) Keep in OFF position CONTROLLER No. Refer to DIP switch setting on page 15 Monitor No. 1 Monitor No. 2 Video Signal RS-485 Signal (Panasonic Security Data Mode)