Pentax SMCPDA Operation Manual - Page 151
Troubleshooting
UPC - 027075892002
View all Pentax SMCPDA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
Troubleshooting 153 We recommend to check the following items before contacting a service center. Symptoms Causes Remedies The shutter does The lens aperture ring setting is Set the lens aperture ring to the not release. other than the s position. s position. (p.60) Nothing is displayed The main switch is OFF. Turn the main switch ON. (p.26) on the LCD panel. The low battery warning } Replace the battery. (p.21) is blinking. The batteries are installed Install the batteries properly. upside-down. (p.21) The mode dial is in the 8 or Set the mode dial to one of the no position. capture modes. The built-in flash is being Wait until the flash is fully charged. charged. (p.86) The Autofocus does The subject is not within the AF Move the camera until subject is not work. frame. inside of the AF frame. (p.17) The subject is too close. Increase the camera-to-subject distance. The focus mode is set to z or Set the focus mode lever to k. l. (p.70) Hard-to-Autofocus subjects Focus manually by using the matte field. (p.74) AE lock function AE lock is not available when Set to one of the capture modes set to green operation mode, a other than the green program 8 does not operate. (Metered manual exposure) AE mode or a (Metered mode or p (bulb) mode. manual exposure) mode. The built-in flash When 3 appears on the LCD (p.86) does not discharge panel, the built-in flash does even if the flash is in not discharge in bright lighting the popped-up position. conditions. The power zoom The camera does not have the Use manual zoom. (p.81) system does not function. power zoom function. In rare cases, the camera may not operate correctly due to static electricity. This can be remedied by taking the batteries out and putting them back in again. When the mirror remains in the up position, take the batteries out and put them back in again. Then, turn the power on, and turn the power off with pressing the shutter release button. The mirror will retract. After the procedure is done, if the camera operates correctly, it does not require any repairs. Appendix