Pfaff 145 Owner's Manual

Pfaff 145 Manual

Get Pfaff 145 PDF manuals and user guides View all Pfaff 145 manuals
Add to My Manuals
Save this manual to your list of manuals

Pfaff 145 manual content summary:

  • Pfaff 145 | Owner's Manual - Page 1
    0 0 0 w 0 0 cI I- (0 (c0) 0)
  • Pfaff 145 | Owner's Manual - Page 2
    1. General The Pfatf 145 is a special-purpose sewing working sleeve take-up and vertical rotary It is chiefly used for sewing Its permissible top speed is multiple plies 2,800 s.p.m. machine equipped hook, which sews with unison forward and feed, smoothly backward. where it is important that
  • Pfaff 145 | Owner's Manual - Page 3
    oiling will increase the service life of your machine. 'tfaaAheefwftceelwpredraryendoosrpusoserparhgs,oaffvooaefonktde, fe in transit, take parts. Apply a 2 and 3, raise a week apply friction. The sewing oilhole R in hook must Fig. 4). be oiled each day the machine is in operation (see
  • Pfaff 145 | Owner's Manual - Page 4
    From time to time remove the and remove the lint which has cussed in Chapter 13. needle plate accumulated after taking underneath. out The set screws cleaning of 1 and 2 (Fig. 4) the hook is dis R 9927 I Fig. 3 R 9928 Fig. 4 3
  • Pfaff 145 | Owner's Manual - Page 5
    sideways, up at one as may end of the be required. bobbin, To do tension and tighten the set screw again. adjust the position this, loosen screw of 7, the bobbin adjust the The tension on the thread is regulated by turning nut 6. Make sure Fig. 5. the bobbin winder pulley rotates in
  • Pfaff 145 | Owner's Manual - Page 6
    the Bobbin and Threading the Bobbin Case Raise the needle to its highest position and open the bed slide. With the thumb of your right hand open latch B (Fig. 6), then push the thumb nail under the projecting flange C of the bobbin case cap and lift the latter out of the machine with thumb
  • Pfaff 145 | Owner's Manual - Page 7
    materials are sewn with round-point needles. Needle and Thread Sizes The correct needle size is select the needle as thin the needle eye easily. dependent as possible, on the fabric and thread weights. For best but make sure the thread can be pulled results, through The needle size machine
  • Pfaff 145 | Owner's Manual - Page 8
    Select the proper needle and thread sizes from the chart below: Model Needle Size Cotton A H1,H2 B H 1, H 2, H 3 H2,H3,H4 D H 3, H 4 60 70 80 90 100 110 120 130 140 150 160 170 180 190 200 130/3 130/4 100/3 100/4 80/3 80/4 70/3-60/3 70/4-60/4 50/3-40/3 50/4-40/4 30/3 30/4 30/6 24/3 24/6 20/3
  • Pfaff 145 | Owner's Manual - Page 9
    needle needle clamp. set screw A (Fig. 8) half a turn, Insert a new sewing hook. securely. needle into the clamp, making Push the needle up as far as sure that it will go its short groove faces toward the and tighten needle set screw A Never use rusty needles 8. Threading the Needle
  • Pfaff 145 | Owner's Manual - Page 10
    it through the needle hole. Lay both threads back under the presser foot, place the material in the machine and lower the presser foot. Hold the ends of both threads until the machine has made a few stitches. 10. Regulating the Thread Tensions Adjusting the Upper Tension Turn tension nut M (Fig
  • Pfaff 145 | Owner's Manual - Page 11
    Adjusting the Lower Tension The tension is correct if when pulling the thread a tension by this screw turning screw clockwise for Z, a If puckering occurs on delicate @as both tensions slightly. materials although the tension has been set machine can be fitted the direction of feed by foot
  • Pfaff 145 | Owner's Manual - Page 12
    1TmtTsOuh2hchapen.reetpeemweRrMapiramareolciegdnoghsuetuisuoilnfnudoleterarHbeteeoblievnfmousesngssaenphwclriytphnethnirhgse.nweseesuiTomsstrfhuhePaoertttheuhret,eteeproisraobeppslrebsrruieseenoiursssguessreteuerxierrfenogoeirjsbnruutealrisadmers.
  • Pfaff 145 | Owner's Manual - Page 13
    a of the hook timing and damage to the bobbin the hook raceway. safety clutch case base in which case prevents of thread disturbance jamming in If an irregulary spun needle sewing hook, the safety clutch thread should jam in the hook raceway automatically disengages the hook drive. and block
  • Pfaff 145 | Owner's Manual - Page 14
    16. Setting the Foot Lift To adapt the (Fig. 15) and crank. Move foot lift. foot lift to the thickness of the material to be sewn, loosen adjust the position of lifting the connection upward for eccentric a higher connection H foot lift, or in the slot downward wing of the for a nut F
  • Pfaff 145 | Owner's Manual - Page 15
    of the Pfaft 145 Equipped with -900 Thread Puller/Trimmer On special request, the Pfaff 145 in Models A and B can be equipped with the timeand cost-saving subcl. -900/06 thread puller/trimmer. On subcl. -900/02 machines, thread trimming, needle positioning and reverse sewing are all controlled
  • Pfaff 145 | Owner's Manual - Page 16
    Chapter 6. Insert new needle. Insert thicker needle. Machine Works Heavily Cause Lack of oil. Wrong lubricant. Hook race obstructed by pieces of thread. Remedy Oil machine as instructed in Chapter 3. Use only non-resinous and acid-free sewing machine oil. Try to free the jammed thread as you rock
  • Pfaff 145 | Owner's Manual - Page 17
    Up the Bobbin Thread 10. Regulating the Thread Tensions 11. Regulating the Stitch Length 12. Regulating the Pressure on the Material . . 13. Cleaning the Sewing Hook 14. The Safety Clutch 15. Changing the Alternating Pressers 16. Setting the Foot Lift 17. The Pfaff 145-900 18. Trouble Shooting Page
  • Pfaff 145 | Owner's Manual - Page 18
    C PFAFFD® Nr. 296-12-12965 engl. P 769 Printed in Germany
  • Pfaff 145 | Owner's Manual - Page 19
    Component Parts for the Pfaff 145 in Models A,B,C,D and H1,H2,H3,H4 Part Name Model Hi H2 H2 H3 H3 H4 A;B A;B C B C;D C;D Balance wheel Standard version 91-009 388-92 91-009 388-92 91-009 389-92 91-009 388-92 c 91-009 389-92 91-
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
0
0
0
w
0
0
I—
cI
(0
(0
c)
0)