Pfaff coverlock 4872 Owner's Manual - Page 34
five-thread safety-stitch
View all Pfaff coverlock 4872 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Thread chain cutter After finishing the seam, sew an approx. 6" -8" (15 -20 cm> long thread chain. Pull the thread chain from the back to the front over the thread chain cutter 40. This will cut off the thread chain. Cbmp spring for serging thread chain 32 Using this feature you can serge the thread chain at the start of the fabric, by pulling it into the seam. Stitch off a minimum 4" (10 cm> long thread chain and raise the presser foot. Remove the thread chain care fully from the swiveling stitch width latch 27. Pull the thread chain forwards and clamp it under the spring. I Place the fabric right in front of the needle(s). If necessary, make an approx. 1.5" (3cm> cut into the fabric along the cut-line using a pair of scissors. Lower the presser foot and start sewing. The thread chain pulls automatically into the inside of the seam. Note: This feature cannot be used for either the five-thread safety-stitch seam, the fourthread safety-stitch seam, the two-thread chainstitch or for the rolled hem. 30