Pfaff creative 1472 Owner's Manual - Page 22
mains, Place, plug., lamp. - sewing machine parts
View all Pfaff creative 1472 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
7- Cleaning and oiling E3 • Pull out the mains plug. S Tilt the needle plate up at the back (A) and remove it (B). Clean the teed dog and the parts in the sewing hook area with a soft brush Clean the bobbin thread monitor as instructed on page 157. Apply a drop of oil in the hook E receway, as shown in the illustration. every 15 lo 20 hours of operation. Other than that, the machine is main tenance-free and must not he oiled. Inserting the needle plate Place the needle plate on with its left side first and press it in until the retai ning hook snaps in audibly. Then press the right side firmly down until it also snaps in, Check the correct posi tion of the needle plate. Changing the fuse Disconnect the mains plug Turn fuse holder A left by a quarter turn with a screwdriver, release it and take it out, Pull out fuse B Insert a new fuse in the holder, replace the holder, push it in with the screwdriver, then turn it right by a quarter turn. (The fuse type is F2A.) 110-volt machines have no fuse. Changing the light bulb: • Disconnect the mains plug. Swing out the work support to the left. Close the hinged top cover and swing up the carrying handle. Insert the edge guide into cutout D, push down the lamp housing and hold it there. Push the bulb upwards, turn it towards A and take it out. Insert the new bulb so that its pins enter slots C Push it up and turn it towards B Pull out the edge guide. Be sure to use only a 15-watt light bulb in the sewing lamp. j - , s;.,.. : 42 Changing the batteries: Switch on the machine, so that the memories are not lost when the batte ries are changed, and tilt the machine over backwards. A battery compart ment is installed in the base. Lift cover B at the catches in recesses A and remove cover Take out the batteries. Insert the new batteries with the plus side (+) facing upwards: Place cover B in so that hinges C engage in recesses 0 and press cover until it snaps in place After changing the batteries, check the contents of the memories. Replacement batteries: 2 Mignon cells, 1.5 V, type LR 6 Only use leak-proof batteries! 4