Pfaff creative 1472 Owner's Manual - Page 52

Embroidery stitch programs ER Multi-colour embroidery Thesemulti colourembroiderypossibilitiessetno limits to your imagination. Carried out with great devotion to detail, colour and decorative etfects, multicolour embroidery gives your clothes the stamp of your personality The following pages are intended as an inspira tion for ornamentation of dresses, blouses and other garments with embroidery motifs made on your Pfaff Creative. Transfer the pattern onto the face side of the fabric with tracing paper Always place two sheets of tissue paper under the material before you start sewing. prog 06 62 65 77 L H f (1j - j -3+ 2A Sewing thread: Embroidery or darning thread Motif 1 is made up of the patterns enumerated above. First workstep: stems • Program 06 • Change the stitch length to 25 mm. • Follow the traced hnes with a program 06 seam. Second workstep: leaves • Program 62 • Change the stitch width to 4.0 mm. • Change the pattern length to 25 • Push the "single pattern" key. • Needle in down position. • Sew the leaf slightly curved, starting at the stem. Leave the needle down in the fabric, turn the fabric through 180° and sew the pattern backwards In this way, all leaves can be sewn larger or smaller. Third workstep: half flower • Program 65 • Stitch width 5.0 mm. • Pattern length: 20 • Push the "single pattern" key. • The tio of the pattern should contact the stem. Fourth workstep: flowers • Program: 62 • Stitch width: 4.5 mm • Pattern length: 20. • Push the "single pattern" key • Sew the petals, including those of the half flower Fifth workstep: flower centre (dot> • Programm 77 • Stitch width: 50mm • Push the "single pattern" key. • Sew the flower centres (dots>. ER ER ER F Border 1 consists of the following programs: Centre motif: 64 Side motif: 39 First workstep: centre motif • Select program 64. • Sew the programmed stitch pattern. Second workstep: side motifs • Select program 39. • Sew the programmed stitch pattern along both sides of the centre motif. The second side motif can be sewn without turning the fabric by pushing the "pattern mirror" key. Border 2 consists of the following programs 506587 First workstep: centre motif • Select program 50. • Sew the programmed stitch pattern. Second workstep: • Select program 65 and change zigzag width to 4-5 mm. • Sew the programmed stitch pattern along both sides of the centre motif Third workstep: side motifs • Enter program 87. • Sew the programmed stitch pattern on both sides along the previously sewn motif. 105 °,