Pfaff hobbylock 4860 Owner's Manual - Page 31
needle set
View all Pfaff hobbylock 4860 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Changing the needle Switch off the main switch. To remove: Lower the sewing foot and put the needle in its highest position. Now push the needle changing aid from the accessories (see page 58) from below right up until it catches over the needle. Loosen set screws (A or B) with the red screwdriver and pull the needle down to remove. To insert: Insert the needle into the hole E of the needle changing aid, with the flat needle shank K facing towards the flat side L of the aid. Insert the needle until it catches in place in the holder and tighten the needle set screw. Remove the needle changing aid. jK Note: The following needles are used for this machine: System EL X 705 (80 or 90) If using the usual sewing needles 130/705 H the thread tension must be increased. 27