Philips 47PFL5704D User manual - Page 24

Use your TV as a PC monitor Use an HDMI-DVI cable or an HDMI-DVI adaptor to connect a PC to your TV. For sound, add an audio cable with a stereo mini jack. Caution • Before you connect your PC, set the PC monitor refresh rate to 60Hz. Supported screen resolutions The following screen resolutions are supported in PC mode: Resolution 640 x 480 800 x 600 1024 x 768 1280 x 768 1280 x 1024 1360 x 768 1920 x 1080* Refresh rate 60Hz 60Hz 60Hz 60Hz 60Hz 60Hz 60Hz *In selected models only If necessary, adjust the picture position to the center of the screen with the cursor buttons. Configure your TV in PC mode 1 Connect the PC to your TV (see 'Connect a PC' on page 29). 2 Press MENU on the remote control and select [Features] > [Mode Selection]. Note • [Mode Selection] appears for the following input signals only: • 720x480p@60 Hz • 1280x720p@60 Hz • 1920x1080p@24/25/30/50/60 Hz TV menu Features Mode Selection Caption settings Sleeptimer Child Lock Change PIN Demo Mode Selection PC HDTV Use Philips EasyLink Your TV supports Philips EasyLink, which enables one-touch play and one-touch standby between EasyLink-compliant devices. Compliant devices must be connected via an HDMI connector. One-touch play When you connect your TV to devices that support one-touch play, you can control your TV and the devices with one remote control. For example, when you press Play on your DVD remote control, your TV automatically switches to the correct channel to show the DVD content. One-touch standby When you connect your TV to devices that support standby, you can use your TV remote control to put your TV and all connected HDMI devices in standby mode.You can perform one-touch standby using the remote control from any of the connected HDMI devices. Activate Master EasyLink 1 Press MENU on the remote control. 2 Select [Installation] > [Preferences] > [Master EasyLink]. 3 Press or to select [On]. Note • Select [Off] to disable this function. [Master EasyLink] must be activated in the [Preferences] menu to make the [TV Speakers] menu available in the [Sound] menu. Use the demo mode You can use demonstrations to better understand the features of your TV. Some demos are not available on certain models.When a demo is available, it is displayed in the menu list. 1 Press MENU on the remote control and select [Features] > [Demo]. TV menu Features Caption settings Sleeptimer Child lock Change PIN Demo Demo Ambilight* 120Hz* Pixel Plus HDNM* Power Usage 3 Select [PC] and press OK to confirm your choice. 4 If necessary, adjust the picture settings. Note • Set the picture format to [Unscaled] for wide-screen PC resolutions. 5 Press MENU to exit. 22 EN *In selected models only 2 Press or to highlight a demo, and press OK to start the demo. 3 Follow the on-screen instructions to enjoy the demo. 4 Press MENU to exit.