Philips AC2885 User manual - Page 19
Troubleshooting
View all Philips AC2885 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
English 8 Troubleshooting This chapter summarizes the most common problems you could encounter with the air purifier. If you are unable to solve the problem with the information below, visit www.philips.com/support or call 1-866-309-8817 for assistance. Problem Possible solution • The air purifier does not work • even though it is • plugged into the wall outlet and switched on. • The air purifier • does not work even though it is switched on. The air purifier accidentally • powers off. How can I know whether my device • is connected version or nonconnected version? The airflow that comes out of the air outlet • is significantly weaker than before. The air quality • does not improve, even though the air purifier has been operating for a long time. • The timer is set to a specific time interval. Reset or turn off the timer. Try a different electrical outlet or check the wall switch. The filter alert status is displaying the filter code. Replace the corresponding filter and reset the filter lifetime counter (see chapter "Replacing the filters"). If the problem persists, visit www.philips.com/support or call 1-866-309-8817 for assistance. The filter replacement indicator has been on continuously but you have not replaced the corresponding filter, and the air purifier is now locked. In this case, replace the filter and reset the filter lifetime counter. The air purifier restarts automatically and goes to the previous mode when the power resumes. Please check the type plate at the backside of the device, model AC2889 is the connected version while model AC2885 is non-connected version. The pre-filter is dirty. Clean the pre-filter (see chapter "Cleaning"). One of the filters has not been placed in the air purifier or a filter is not placed properly. Make sure that all filters are properly installed in the following order, starting with the innermost filter: 1) NanoProtect True HEPA filter (FY2422); 2) NanoProtect Active Carbon filter (FY2420); 3) pre-filter. The air quality sensor is wet. Make sure that the air quality sensor is clean and dry (see chapter "Cleaning"). EN 17