Philips AZ4000 User manual - Page 12

English Digital Tuner Tuning to Stations MP3-CD PLAYBACK FM/AM stereo CD MODE PROGRAM PRESET/ ALBUM SEARCH SLEE 1 Press the POWER y button. 2 Press SOURCE once or more to select TUNER (or press TUNER once on the remote control). ➜ Display: shows briefly followed by waveband, frequency and preset station number if already stored. 3 Press FM/AM once or more to select the desired waveband. 4 Tuning to stations: you can tune to your stations manually or by automatic search tuning: Press SEARCH ∞ or § (or TUNING 5 , 6 on the remote control) and release when the frequency in the display starts running. ➜ The radio automatically tunes to a station of sufficient reception. Display shows during automatic tuning. ➜ Repeat step 3 if necessary until you find the desired station. To tune to a weak station, press SEARCH ∞ or § briefly and repeatedly until you have found optimal reception. Improving reception - For FM, pull out the telescopic antenna. Incline and turn the antenna. Reduce its length if the signal is too strong (very close to a transmitter). ➜ Display shows stereo if FM station is received in stereo. - For AM the set is provided with a built-in antenna so the telescopic antenna is not needed. Direct the antenna by turning the whole set. 5 To switch off the tuner, press POWER y. Programming tuner stations Store up to a total of 30 tuner stations in the memory, manually or automatically.You can also erase a preset station by storing another frequency in its place. Autostore Automatic programming will start with a chosen preset number. From this preset number upwards, former programmed tuner stations will be erased.The unit will only program stations which are not in the memory already. MP3-CD PLAYBACK FM/AM stereo CD MODE PROGRAM PRESET/ ALBUM SEARCH SLEEP DISPLAY 1 Press PRESET / ALBUM - or + once or more to select the preset number where programming should start. Note: If no preset number is selected, default is preset 1 and all your presets will be erased. 12