Philips AZ4000 User manual - Page 19

Troubleshooting

Get Philips AZ4000 PDF manuals and user guides View all Philips AZ4000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

English Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair. Do not open the set as there is a risk of electric shock. If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty. Problem Solution No sound/power - Volume not adjusted. Adjust the VOLUME. - Power cord not securely connected. Connect AC power cord properly. - Batteries dead /incorrectly inserted. Insert (fresh) batteries correctly. Display does not function properly/ No reaction to operation of any of the controls - Electrostatic discharge. Switch off and unplug the set. Reconnect after a few seconds. INSERT CD or CHECK DISC indication - No CD inserted, insert a CD. - CD badly scratched or dirty. Replace/ clean CD (see Maintenance). - Laser lens steamed up.Wait until lens has cleared. - CD-R(W) is blank or the disc is not finalized. Use a finalized CD-R(W). CD playback does not work - CD badly scratched/ dirty. Replace/ clean CD (see Maintenance). - Laser lens steamed up. Wait until lens has acclimatized. The CD skips tracks - Disc damaged or dirty. Replace or clean disc. - SHUFFLE or a program is active. Quit SHUFFLE / program mode(s). 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
English
19
If a fault occurs, first check the points listed below before taking the set for repair. Do
not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or
service center.
WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the warranty.
Troubleshooting
Problem
Solution
No sound/power
– Volume not adjusted.Adjust the VOLUME.
– Power cord not securely connected.
Connect AC power cord properly.
– Batteries dead /incorrectly inserted.
Insert (fresh) batteries correctly.
Display does not function
– Electrostatic discharge.
properly/ No reaction to
Switch off and unplug the set.
operation of any of the
Reconnect after a few seconds.
controls
INSERT CD or CHECK DISC
– No CD inserted, insert a CD.
indication
– CD badly scratched or dirty.
Replace/ clean CD (see
Maintenance
).
– Laser lens steamed up.Wait until lens has cleared.
– CD-R(W) is blank or the disc is not finalized.
Use a finalized CD-R(W).
CD playback does not work
– CD badly scratched/ dirty.
Replace/ clean CD (see
Maintenance
).
– Laser lens steamed up.
Wait until lens has acclimatized.
The CD skips tracks
– Disc damaged or dirty. Replace or clean disc.
– SHUFFLE or a program is active.
Quit SHUFFLE / program mode(s).