Philips BTM2180 User manual - Page 9

Prepare the remote control Caution •• Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire. •• Risk of decreased battery life! Never mix different brands or types of batteries. •• Risk of product damage! When the remote control is not used for long periods, remove the batteries. To insert the remote control battery: 1 Open the battery compartment. 2 Insert the supplied AAA battery with correct polarity (+/-) as indicated. 3 Close the battery compartment. Set clock 1 In standby mode, press and hold CLOCK on the remote control for more than two seconds. »» [24H] or [12H] hour format is displayed. 2 Press / to select [24H] or [12H] hour format. 3 press CLOCK to confirm. »» The hour digits are displayed and begin to blink. 4 Repeat steps 2-3 to set hour and minute. Note •• If no button is pressed in 90 seconds, the system exits clock setting mode automatically. Tip •• You can view clock information in power-on mode by pressing CLOCK. Turn on Press . »» The unit switches to the last selected source. Switch to standby mode Press again to switch the unit to standby mode. »» The clock (if set) is displayed on the panel. Switch to ECO standby mode: Press and hold for more than two seconds. »» The display panel is dimmed. Note •• The unit switches to Eco Power Standby mode after 15 minutes in standby mode. Switch between standby mode and ECO standby mode: Press and hold for more than two seconds. 9 EN