Philips FWP88P User manual - Page 18

English CD Playing a CD 1 Press PLAYÉÅto start playback. ™ The disc tray, track number and elapsed playing time of the current track appear on the display. • To interrupt playback, press PAUSEÉÅ. ™ The playing time flashes. • To resume playback, press PLAYÉÅ again. 2 To stop playback, press Ç. Notes: - All the available discs will play once, then stop. - When the CD has stopped playing, the system will switch to standby mode after 30 minutes if no button is pressed. Disc Change You can change the outer two discs while the third inner disc is stopped or is playing. 1 Press DISC CHANGE. ™ The CD carousel tray slides out. 2 Replace the discs in the left and right disc trays. • If you wish to change the inner disc during playback, press DISC CHANGE again. ™ "DISC CHANGE" will be displayed. ™ The CD will stop playing. ™ The CD carousel tray will close to retrieve the inner CD and then open again with the inner CD accessible. 3 Press OPEN•CLOSE to close the CD carousel tray. Selecting a desired track Selecting a desired track when playback is stopped 1 Press í or ë (or Digit 0-9 on the remote control) until the desired track appears on the display. 2 Press PLAYÉÅ to start playback. ™ The selected track number and elapsed playing time appear on the display. Selecting a desired track during playback • Press í or ë (or Digit 0-9 on the remote control) until the desired track appears on the display. ™ The selected track number and elapsed playing time appear on the display. • If you press í once it will skip to the beginning of the current track and play the track again. Note: - Pressingí during shuffling can only skip to the beginning of the current track. Searching for a particular passage during playback • Press and hold à or á until the desired passage is located. ™ The volume will be reduced. • Play returns to normal when à or á is released. Programming Tracks Programming tracks of a loaded CD is possible when playback is stopped. The display will indicate the total tracks stored in the program. Up to 40 tracks can be stored in the memory in any order. When 40 tracks are stored and you attempt to store another track, the display will show "PROGRAM FULL". 1 Load the desired discs in the disc trays. 2 Press PROG to start programming. ™ The PROGRAM starts flashing. ™ It will cancel any previously selected repeat mode. 3 Press the CD (CD 1•2•3) or DISC 1/2/3 button to select the disc. 4 Press í or ë (or Digit 0-9 on the remote control) to select the desired track. 5 Press PROG to store the track. • Repeat steps 3 to 5 to store other discs and tracks. 6 Press Ç once to end programming. ™ The total number of tracks programmed and total playing time appear on the display. Notes: - If the total playing time is more than "99:59" or if one of the programmed tracks has a number greater than 30, then "--:--" appears on the display instead of the total playing time. 18 pg 01-31/P88/22-Eng 18 3/6/00, 1:26 PM 3139 116 19721