Philips FWP88P User manual - Page 27

PERSONAL DS English CLOCK TIMER STANDBY ON POWER SAVE MINI HIFI SYSTEM LEFT CENTER RIGHT SURR SURR PRO LOGIC DOLBY B NR NEWS/TA RDS 5 Press CLOCK/TIMER again to store the setting. ™ The clock starts. • To exit without storing the setting, press Ç on the system. Timer Setting • The system can switch on to CD, TUNER, or TAPE 2 mode automatically at a preset time. It can serve as an alarm to wake you up. IR SENSOR VEC C BASS/TREBLE CD 1•2•3 BAND TAPE 1•2 CDR/DVD C1C•D2 • 3 BTAUNNDER TAPE SEARCH•TUNING STOP•CLEAR PLAY PAUSE v ACUDRX PRESET v PREV SIDE NEXT PROG CLOCK/ TIMER DIM A. REV DUB (HSD) RECORD BASS PLUS wOOx TECHNOLOGY LEVEL TREBLE VOLUME CD TEXT Notes: - During clock setting, if no button is pressed within 90 seconds, the system will exit clock setting mode automatically. - When a power interruption occurs, the clock setting is erased. - To set the time with RDS clock, see • Before setting the timer, make sure the clock is set correctly. • The timer will always be switched on once it is set. • The volume of the timer will increase from the minimum level until the volume level before the set is switched to standby mode. View Clock Clock Setting "Receiving RDS Radio Station" under TUNER section. 1 Press and hold CLOCK/TIMER for more than 2 seconds to select timer mode. You can view the clock (if it is set) if the system is in Standby mode or when any sound source is selected (CD, TUNER, etc.). The clock will be displayed for about 7 seconds. • Press CLOCK/TIMER briefly (or CLOCK on the remote control). ™ "PM 10:38 or 22:38" (the current time) will be displayed depending on whether you have selected 12- or 24-hour mode will be displayed if the clock is not set. Note: - When the system goes into low power standby mode, the clock setting will not The clock can be set in either 12- or 24hour mode, e.g. "AM 12:00" or "00:00". Before setting the clock, you must be in the View Clock mode. 1 Press CLOCK/TIMER to select clock mode. 2 Press PROG (on the system only) to select 12- and 24- hour mode. ™ If 12-hour mode is selected, "AM 12:00" starts flashing. ™ If 24-hour mode is selected, "00:00" starts flashing. 3 Set the hour with␣ à or á on the system. 4 Set the minute with␣ í or ë on the system. ™ "AM 12:00" or "00:00" or the last timer setting starts flashing depending on whether you have selected 12- or 24-hour mode. ™ The TIMER starts flashing. ™ The selected source is lit while other available sources are flashing. 2 Press CD, TUNER or TAPE to select the desired source. • Before selecting CD or TAPE, make sure a CD or tape is loaded in the CD tray or tape deck 2. 3 Press␣ à or á on the system to set the hour for the timer to start. 4 Press␣ í or ë on the system to set the minute for the timer to start. be displayed. 27 pg 01-31/P88/22-Eng 27 3/6/00, 1:28 PM 3139 116 19721