Philips HDP2510 User manual - Page 12

Installing or changing the batteries of the IR remote control DANGER! Risk of explosion with incorrect type of batteries! Only use the AAA type battery. 1 To access the battery, press to unlock the locking mechanism (1) and slide out the battery compartment (2). a b 2 Insert the new batteries into the battery compartment with the positive and negative poles as shown. Make sure the polarities  (+ and -) are aligned correctly. Using the remote control The remote control can be used within an angle of 22.5 degrees and up to 10 meters from the device. When using the remote control, there should be no obstacles between the remote control and the remote sensor. CAUTION! • The improper use of batteries can lead to overheating, explosion, risk of fire and injury. Leaking batteries can possibly damage the remote control. • Never expose the remote control to direct sunlight. • Avoid deforming, dismantling or charging the batteries. • Avoid exposure to open fire and water. • Replace empty batteries immediately. • Remove the battery from the remote control if not in use for long periods of time. 3D glasses (optional) Notice You can purchase Screeneo 3D glasses on the Philips website: www.philips.com 3 Push the battery compartment back into the remote control until the locking mechanism engages. Notice Normally the batteries will last for around one year. If the remote control stops working, replace the batteries. If the device is not used for a long time, take out the batteries. This will prevent leakage and possible damage to the remote control. The used batteries should be disposed of according to the recycling regulations of your country. The 3D glasses are equipped with a battery, which has to be charged before first use. Charging takes several hours and is complete when the LED on the glasses is on green. When the LED turns red, do a new charge. 1 Take a USB mini cable, connect the USB mini plug to the 3D glasses and the other end of the cable to a USB port. 12 Philips · HDP2510