Philips HDP2510 User manual - Page 14

Initial installation 1 Turn the device with the rear side towards a suitable projection surface or wall. Note that the distance to the projection surface must be a minimum of 0.1 meter and a maximum of 0.42 meter (see Setting up the device, page 4). Make sure the projector is in a secure position. Notice The turning on and off of the projector requires some time, as the UHP lamp must reach the operational temperature. After a few minutes the brightness reaches its full capacity. Turning on the projector 1 To turn on the projector, press the B button on the panel control of the device or on the remote control once. 3 The first time you turn on the device, you need to set the following settings. Notice During the first installation, use OK to validate your choice and continue to the next step, and ¿ to return to the previous step. 4 Use ¡/¢ to select the language and confirm with OK. Language Please choose your Language Český Dansk Deutsch English OK Español Francais Italiano 5 Use ¡/¢ to select the location and confirm with OK. Location Please choose the location where your Screeneo should be placed Shop OK Home 2 Use the FOCUS buttons N/O to adjust the image sharpness. Home: For normal use. Shop: When you choose this option, the projector starts in shop mode. In this mode default settings are made and can't be changed. Notice The shop mode can be activated or deactivated on the Option menu (see Shop Mode Switches the shop mode On and Off., page 27). 14 Philips · HDP2510